Analysis of Machining Parameters in WEDM of Al/SiCp20 MMC Using Taguchi-Based Grey-Fuzzy Approach
Open Access
- 25 February 2019
- journal article
- research article
- Published by Wiley in Modelling and Simulation in Engineering
- Vol. 2019, 1-13
Abstract
Aluminium silicate metal matrix composite (AlSiC MMC) is satisfying the requirement of material with good mechanical, thermal properties, and good wear resistance. But the difficulties during the machining are the main hurdles to its replacement for other materials. Wire electric discharge machining (WEDM) is a very effective process used for this type of difficult-to-cut material. So an effort has been taken to find out the most favourable level of input parameters for WEDM of AlSiC (20%) composite using a Taguchi-based hybrid grey-fuzzy grade (GFG) approach. The plan for experimentation is designed using Taguchi’s L9 (23) array. The various process parameters considered for the investigation are pulse on time (TON), pulse off time (TOFF), wire feed rate (WFR), and peak current (IP). Surface integrity such as surface roughness measured during the different types of cutting (along straight, inclined, and curvature directions) is considered in the present work. Grey relational analysis (GRA) pooled with the fuzzy logic is effectively used to find out the grey-fuzzy reasoning grade (GFRG). The Taguchi approach is coupled with the GFRG to obtain the optimum set of process parameters. From the experimental findings, it has been observed that the most economical process parameters for WEDM of AlSiCp20 were the pulse on time is 108 microsec, pulse off time is 56 microsec, wire feed rate (WFR) is 4 m/min, and peak current (IP) is 11 amp. From the analysis of variance (ANOVA), it is observed that the pulse on time is the foremost influencing parameters that contribute towards GFRG by 52.61%, followed by the wire feed rate (WFR) 38.32% and the current by 5.45%.Keywords
This publication has 12 references indexed in Scilit:
- Multi-objective optimization in WEDM process of nanostructured hardfacing materials through hybrid techniquesMeasurement, 2016
- A novel approach integrating dimensional analysis and neural networks for the detection of localized faults in roller bearingsMeasurement, 2016
- Effect of wire EDM conditions on generation of residual stresses in machining of aluminum 2014 T6 alloyAlexandria Engineering Journal, 2016
- Effect of dielectric fluid with surfactant and graphite powder on Electrical Discharge Machining of titanium alloy using Taguchi methodEngineering Science and Technology, an International Journal, 2015
- Modelling and analysis of material removal rate and surface roughness in wire-cut EDM of armour materialsEngineering Science and Technology, an International Journal, 2015
- Formulation of Mathematical Model for the Investigation of Tool Wears in Boring Machining Operation on Cast Iron Using Carbide and CBN ToolsProcedia Materials Science, 2014
- Optimization of cutting conditions of YG15 on rough and finish cutting in WEDM based on statistical analysesThe International Journal of Advanced Manufacturing Technology, 2013
- Optimization of wire electrical discharge machining of pure tungsten using neural network and response surface methodologyProceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture, 2011
- Modeling and prediction of surface roughness in turning operations using artificial neural network and multiple regression methodExpert Systems with Applications, 2011
- Performance comparison of conventional and wiper ceramic inserts in hard turning through artificial neural network modelingThe International Journal of Advanced Manufacturing Technology, 2010