The design and additive manufacturing of an eco-friendly mold utilized for high productivity based on conformal cooling optimization

This publication has 26 references indexed in Scilit:

• Optimizing the coupled effects of Hall-Petch and precipitation strengthening in a Al 0.3 CoCrFeNi high entropy alloy
  Materials & Design, 2017
• Design of conformal cooling for plastic injection moulding by heat transfer simulation
  Polímeros, 2015
• Influence of cooling rate on the microstructure and corrosion behavior of Al–Fe alloys
  Corrosion Science, 2015
• Spray forming of hypereutectic Al–Si alloys
  Journal of Materials Processing Technology, 2009
• Endwall heat transfer and pressure drop in rectangular channels with attached and detached circular pin-fin array
  International Journal of Heat and Mass Transfer, 2008
• Pressure drop and heat transfer of square pin-fin arrays in in-line and staggered arrangements
  International Journal of Heat and Mass Transfer, 2007
• Morphologies of primary silicon in hypereutectic Al–Si alloys with melt overheating temperature and cooling rate
  Materials Science and Engineering: A, 2006
• An Overview of the Development of Al-Si-Alloy Based Material for Engine Applications
  Journal of Materials Engineering and Performance, 2003
• Computations of Complex Turbulent Flows Using the Commercial Code Fluent
  1999
• Dislocation generation due to differences between the coefficients of thermal expansion
  Materials Science and Engineering, 1986