Thermal Analysis of Sheet Beam Gun for the Sheet Beam Traveling Wave Tube
Authors:
- 3 February 2016
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 63 (3) , 1312-1316
Abstract
The sheet beam gun (SBG) is operated at high temperature, and thermal expansion could induce huge electron beam degeneration. The previous SBG design, which did not take account of thermal expansion, obtained bad transportation performance. Experimental measurement showed that the distance variation between a cathode and an anode was larger than 0.42 mm, which could hugely degenerate beam performance. A new inner support rod with grooves was employed in this paper, and the heat power was reduced from 27 to 15.5 W, while the distance variation was reduced to 0.29 mm. The new SBG with adjustment according to the thermal expansion was fabricated and tested. The transportation rate after anode tunnel was enhanced to 98%, and the total transportation rate of sheet beam traveling wave tube with a period permanent magnet focusing structure was about 90%.Keywords
Funding Information
- National Natural Science Foundation of China (G0501040161101040)
This publication has 7 references indexed in Scilit:
- System Design Analysis of a 0.22-THz Sheet-Beam Traveling-Wave Tube AmplifierIEEE Transactions on Electron Devices, 2011
- Modeling Investigation of an Ultrawideband Terahertz Sheet Beam Traveling-Wave Tube Amplifier CircuitIEEE Transactions on Electron Devices, 2011
- Demonstration of a 100-kW Solenoidally Focused Sheet Electron Beam for Millimeter-Wave AmplifiersIEEE Transactions on Electron Devices, 2011
- 9.4: MEMS fabrication of 0.22 THz sheet beam TWT circuit2010
- 8.4: Terahertz sheet beam gun analyzer2010
- Electron beam transport analysis of W-band sheet beam klystronPhysics of Plasmas, 2010
- Modern Microwave and Millimeter-Wave Power Electronics2005