Synthesis and physicochemical properties of adsorbents based on Li1.33Mn1.67O4
Open Access
- 4 March 2023
- journal article
- research article
- Published by Publishing House Belorusskaya Nauka in Doklady of the National Academy of Sciences of Belarus
- Vol. 67 (1) , 27-37-37
Abstract
Adsorbents based on binary lithium-manganese oxides with the spinel structure of Li1.33Mn1.67O4 were synthesized by using solid-phase, sol-gel, and hydrothermal methods. The effect of the synthesis methods and calcination temperature on the crystal structure, phase composition, textural characteristics, and morphology of prepared adsorbents was established. It was found that the samples obtained by solid-phase and sol-gel methods and calcined at 600 °C were single-phase (Li1.33Mn1.67O4) while the Mn2O3 trace phase was also obtained only in hydrothermal synthesis. The increase in the average crystallite size and the decrease in the specific surface and the total volume of pores were observed during temperature rise in the range from 400 to 800 °C. The samples prepared by sol-gel and hydrothermal methods after at 600 °C calcination had the highest adsorption efficiency of Li+ ions.Keywords
This publication has 10 references indexed in Scilit:
- Recent advances in magnesium/lithium separation and lithium extraction technologies from salt lake brineSeparation and Purification Technology, 2021
- Prospects for lithium-ion batteries and beyond—a 2030 visionNature Communications, 2020
- Circular economy strategies for electric vehicle batteries reduce reliance on raw materialsNature Sustainability, 2020
- Metal oxide sorbents for the sustainable recovery of lithium from unconventional resourcesApplied Materials Today, 2020
- Lithium Recovery from Aqueous Resources and Batteries: A Brief ReviewJohnson Matthey Technology Review, 2018
- From hydrated layered-spinel lithium manganate composite to high-performance spinel LiMn2O4: A novel synthesis tuned by the concentration of LiOHCeramics International, 2017
- Physisorption of gases, with special reference to the evaluation of surface area and pore size distribution (IUPAC Technical Report)Pure and Applied Chemistry, 2015
- Unusual Compressional Behavior of Lithium–Manganese Oxides: A Case Study of Li4Mn5O12The Journal of Physical Chemistry C, 2012
- Highly crystalline lithium–manganese spinel prepared by a hydrothermal process with co-solventJournal of Power Sources, 2011
- Sol-gel synthesis of normal spinel LiMn2O4 and its characteristicsJournal of Wuhan University of Technology-Mater. Sci. Ed., 2002