Novel nanoscale thermal property imaging technique: The 2ω method. II. Demonstration and comparison
Authors:
- 1 September 2006
- journal article
- Published by American Vacuum Society in Journal of Vacuum Science & Technology B: Microelectronics and Nanometer Structures Processing, Measurement, and Phenomena
- Vol. 24 (5) , 2405-2411
Abstract
This paper presents the method, a newly developed ac mode local thermal property imaging technique with nanoscale spatial resolution. The authors batch-fabricate the thermoelectric probe, whose junction size is about , with yield higher than 95%. The shortest time constant of the thermoelectric probe is measured to be . They experimentally demonstrate that the method can map out the local thermal property of a sample by monitoring the amplitude of the signal from the thermocouple junction of a probe heated by an ac. By comparing with the thermal property images obtained by other methods, they also show that the method using the point-heating and point-sensing scheme is the most suitable for the nanoscale thermal property imaging.
Keywords
This publication has 6 references indexed in Scilit:
- Application of a Wollaston wire probe for quantitative thermal analysisThermochimica Acta, 2002
- Design and batch fabrication of probes for sub-100 nm scanning thermal microscopyJournal of Microelectromechanical Systems, 2001
- Thermal Transport Mechanisms at Nanoscale Point ContactsJournal of Heat Transfer, 2001
- SCANNING THERMAL MICROSCOPYAnnual Review of Materials Science, 1999
- Sensor nanofabrication, performance, and conduction mechanisms in scanning thermal microscopyJournal of Vacuum Science & Technology B: Microelectronics and Nanometer Structures Processing, Measurement, and Phenomena, 1997
- Thermal conductivity measurement from 30 to 750 K: the 3ω methodReview of Scientific Instruments, 1990