Effect of Pressure and Particle Size During Aluminum Oxide Air Abrasion on the Flexural Strength of Disperse-Filled Composite and Polymer-Infiltrated Ceramic Network Materials
Open Access
Abstract
Esthetic dental computer-aided design/computer-aided manufacturing (CAD/CAM) polymers such as disperse-filled composites (DFC) and polymer-infiltrated ceramic networks (PICN) should be subjected to surface treatment before bonding. However, such treatment can lead to defect formation and a decrease in strength. Therefore, in this study, we compared the flexural strengths of DFC and PICN materials air-abraded with alumina particles of different sizes at different pressures. In addition to Weibull analysis, the samples (untreated and treated) were characterized by scanning electron microscopy and atomic force microscopy. Both DFC and PICN exhibited the lowest flexural strength at large particle sizes and high pressures. Therefore, we optimized the air abrasion parameters to maintain the flexural strength and significantly increase surface roughness. In the case of DFC, the optimal particle size and pressure conditions were 50 µm at 2 bar and 110 µm at 1 bar, while for PICN, the best performance was obtained using Al2O3 particles with a size of 50 µm at 1 bar. This study reveals that optimization of the surface treatment process is crucial in the fabrication of high-performance clinical materials for dental restorations.Keywords
Funding Information
- Ministry of Trade, Industry and Energy (10077361)
This publication has 35 references indexed in Scilit:
- Long-term tensile bond strength of differently cemented nanocomposite CAD/CAM crowns on dentin abutmentDental Materials, 2014
- High-temperature-pressure Polymerized Resin-infiltrated Ceramic NetworksJournal of Dental Research, 2013
- Properties of experimental urethane dimethacrylate-based dental resin composite blocks obtained via thermo-polymerization under high pressureDental Materials, 2013
- Wear characteristics of current aesthetic dental restorative CAD/CAM materials: Two-body wear, gloss retention, roughness and Martens hardnessJournal of the Mechanical Behavior of Biomedical Materials, 2013
- Influence of Y-TZP ceramic treatment and different resin cements on bond strength to dentinDental Materials, 2012
- Slow crack growth and reliability of dental ceramicsDental Materials, 2011
- Fatigue behavior in water of Y-TZP zirconia ceramics after abrasion with 30 μm silica-coated alumina particlesDental Materials, 2011
- A review of adhesion scienceDental Materials, 2010
- Computer-aided design and fabrication of dental restorationsThe Journal of the American Dental Association, 2006
- Mechanical Properties of Feed Pellets: Weibull AnalysisBiosystems Engineering, 2003