55-TW magnetically insulated transmission-line system: Design, simulations, and performance
Authors:
- W. A. StygarWSW. A. Stygar
- P. A. CorcoranPCP. A. Corcoran
- H. C. IvesHIH. C. Ives
- R. B. SpielmanRSR. B. Spielman
- J. W. DouglasJDJ. W. Douglas
- B. A. WhitneyBWB. A. Whitney
- M. A. MostromMMM. A. Mostrom
- T. C. WagonerTWT. C. Wagoner
- C. S. SpeasCSC. S. Speas
- T. L. GillilandTGT. L. Gilliland
- G. A. AllshouseGAG. A. Allshouse
- R. E. ClarkRCR. E. Clark
Open Access
- 7 December 2009
- journal article
- research article
- Published by American Physical Society (APS) in Physical Review Special Topics - Accelerators and Beams
- Vol. 12 (12) , 120401
Abstract
We describe herein a system of self-magnetically insulated vacuum transmission lines (MITLs) that operated successfully at 20 MA, 3 MV, and 55 TW. The system delivered the electromagnetic-power pulse generated by the accelerator to a physics-package load on over 1700 shots. The system included four levels that were electrically in parallel. Each level consisted of a water flare, vacuum-insulator stack, vacuum flare, and 1.3-m-radius conical outer MITL. The outputs of the four outer MITLs were connected in parallel by a 7.6-cm-radius 12-post double-post-hole vacuum convolute. The convolute added the currents of the four outer MITLs, and delivered the combined current to a single 6-cm-long inner MITL. The inner MITL delivered the current to the load. The total initial inductance of the stack-MITL system was 11 nH. A 300-element transmission-line-circuit model of the system has been developed using the tl code. The model accounts for the following: (i) impedance and electrical length of each of the 300 circuit elements, (ii) electron emission from MITL-cathode surfaces wherever the electric field has previously exceeded a constant threshold value, (iii) Child-Langmuir electron loss in the MITLs before magnetic insulation is established, (iv) MITL-flow-electron loss after insulation, assuming either collisionless or collisional electron flow, (v) MITL-gap closure, (vi) energy loss to MITL conductors operated at high lineal current densities, (vii) time-dependent self-consistent inductance of an imploding -pinch load, and (viii) load resistance, which is assumed to be constant. Simulations performed with the tl model demonstrate that the nominal geometric outer-MITL-system impedance that optimizes overall performance is a factor of greater than the convolute-load impedance, which is consistent with an analytic model of an idealized MITL-load system. Power-flow measurements demonstrate that, until peak current, the stack-MITL system performed as expected. tl calculations of the peak electromagnetic power at the stack, stack energy, stack voltage, outer-MITL current, and load current, as well as the pinch-implosion time, agree with measurements to within 5%. After peak current, tl calculations and measurements diverge, which appears to be due in part to the idealized pinch model assumed by tl. The results presented suggest that the design of the accelerator’s stack-MITL system, and the tl model, can serve as starting points for the design of stack-MITL systems of future superpower accelerators.
Keywords
This publication has 34 references indexed in Scilit:
- Tailoring of electron flow current in magnetically insulated transmission linesPhysical Review Special Topics - Accelerators and Beams, 2009
- Development of Instabilities in Wire-ArrayPinchesPhysical Review Letters, 2008
- Three-dimensional effects in trailing mass in the wire-array Z pinchPhysics of Plasmas, 2008
- Architecture of petawatt-class-pinch acceleratorsPhysical Review Special Topics - Accelerators and Beams, 2007
- Losses at magnetic nulls in pulsed-power transmission line systemsPhysics of Plasmas, 2006
- Flashover of a vacuum-insulator interface: A statistical modelPhysical Review Special Topics - Accelerators and Beams, 2004
- Analytic electrical-conductivity tensor of a nondegenerate Lorentz plasmaPhysical Review E, 2002
- Particle-in-cell simulations of electron flow in the post-hole convolute of the Z acceleratorPhysics of Plasmas, 2001
- Flashover of vacuum interfaces with many stages and large transit timesIEEE Transactions on Plasma Science, 1997
- Analytic model of Applied-B ion diode impedance behaviorJournal of Applied Physics, 1987