Low-Frequency Regenerative Vibration and the Formation of Lobed Holes in Drilling
Authors:
- 29 April 2002
- journal article
- Published by ASME International in Journal of Manufacturing Science and Engineering
- Vol. 124 (2) , 275-285
Abstract
Large-amplitude vibrations in drilling often occur at frequencies near multiples of the rotation frequency, even when these are much lower than the system’s first natural frequency. These vibrations are responsible for out-of-round, “lobed” holes. A simplified model of the mechanics of this phenomenon is presented in this paper. The model includes cutting and “rubbing” forces on the drill, but inertia and damping of the tool are neglected at low speeds. This quasi-static model remains dynamic because of the regenerative nature of cutting; the force on each cutting element depends on both the tool’s current position and its position at the time of the previous tooth passage. Characteristic solutions, including unstable retrograde “whirling” modes, are found in terms of eigenvalues and eigenvectors of a discrete state-transition matrix. These unstable modes correspond closely to behavior observed in drilling tests.Keywords
This publication has 26 references indexed in Scilit:
- Suppression of Chatter Vibration in DrillingJournal of Manufacturing Science and Engineering, 1998
- Pattern formation and linear stability analysis in centreless grindingProceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture, 1997
- COMPLEX GEOMETRY, ROTARY INERTIA AND GYROSCOPIC MOMENT EFFECTS ON DRILL VIBRATIONSJournal of Sound and Vibration, 1995
- Detection and Suppression of Drilling ChatterJournal of Dynamic Systems, Measurement, and Control, 1994
- Calculation of main cutting edge forces and torque for drills with arbitrary point geometriesInternational Journal of Machine Tools and Manufacture, 1992
- Effects of Geometric and Process Parameters on Drill Transverse VibrationsJournal of Engineering for Industry, 1990
- Modeling and Finite Element Analysis of Drill Bit VibrationsJournal of Vibration and Acoustics, 1989
- Drilling model for cutting lip and chisel edge and comparison of experimental and predicted results. IV — drilling tests to determine chisel edge contribution to torque and thrustInternational Journal of Machine Tool Design and Research, 1985
- Drilling model for cutting lip and chisel edge and comparison of experimental and predicted results. I — initial cutting lip modelInternational Journal of Machine Tool Design and Research, 1985
- New Developments in the Theory of the Metal-Cutting Process: Part I. The Ploughing Process in Metal CuttingJournal of Engineering for Industry, 1960