A model for seismic velocity and attenuation in petroleum source rocks
- 1 January 2000
- journal article
- Published by Society of Exploration Geophysicists in Geophysics
- Vol. 65 (4) , 1080-1092
Abstract
Petroleum source rock is modeled as a viscoelastic transversely isotropic medium composed of illite/smectite and organic matter. The wave velocities and attenuation of petroleum source rocks are obtained as a function of excess pore pressure, initial kerogen content, and water saturation. The model generalizes a previous approach based on a pure elastic formulation of Backus averaging and introduces the pressure effect and the presence of fluids (oil and water). The model allows the simulation of different maturation levels induced by pore-pressure changes caused by the conversion of kerogen to oil. The higher the oil saturation, the higher the maturation level. Assuming that the source rock has a very low permeability, the excess pore pressure can be calculated as a function of the conversion factor. Then the bulk modulus and density of the kerogen/oil mixture are obtained with the Kuster and Toksöz model, assuming that oil is the inclusion in a kerogen matrix. Finally, Backus averaging of this mixture with the illite/smectite layers gives the complex stiffnesses of the transversely isotropic and anelastic medium. Computed P- and S-velocities and quality factors parallel to bedding are higher than those normal to bedding, with attenuation anisotropy higher than stiffness anisotropy. In particular, for the North Sea Kimmeridge Shale and at maximum anisotropy, P and S parallel velocities are approximately 0.7 km/s higher than the corresponding P and S normal velocities. The maximum attenuation and stiffness anisotropies are obtained for 18% and 30% volumetric kerogen content, respectively. Both velocities and quality factors decrease with increasing kerogen content at a given pore pressure. The decrease in wave velocity is 2 km/s for P-waves and 1 km/s for S-waves when kerogen increases from zero to 100%. Moreover, anisotropy increases and velocities decrease with increasing pore pressure, i.e., with higher kerogen-to-oil conversion. Finally, the presence of water affects the normal-bedding velocity, i.e., higher water saturation implies lower velocities.Keywords
This publication has 13 references indexed in Scilit:
- Seismic pore space compressibility and Gassmann's relationGeophysics, 1995
- ANISOTROPIC Q AND VELOCITY DISPERSION OF FINELY LAYERED MEDIA1Geophysical Prospecting, 1992
- A calculus for finely layered anisotropic mediaGeophysics, 1989
- Physical properties of shale at temperature and pressureGeophysics, 1987
- Weak elastic anisotropyGeophysics, 1986
- Measurements of attenuation from vertical seismic profilesGeophysics, 1981
- Seismic Waves and Sources1981
- Velocity and attenuation of seismic waves in two-phase media; Part I, Theoretical formulationsGeophysics, 1974
- Effect of pore pressure on the velocity of compressional waves in low-porosity rocksJournal of Geophysical Research, 1972
- A Theory Relating High Temperatures and OverpressuresJournal of Petroleum Technology, 1970