An Analytical Approach for the Evaluation of the Optimal Combustion Phase in Spark Ignition Engines
- 24 November 2009
- journal article
- Published by ASME International in Journal of Engineering for Gas Turbines and Power
- Vol. 132 (3) , 032802
Abstract
It is well known that the spark advance is one of the most important parameters influencing the efficiency of a spark ignition engine. A change in this parameter causes a shift in the combustion phase, whose optimal position, with respect to the piston motion, implies the maximum brake mean effective pressure for given operative conditions. The best spark timing is usually estimated by means of experimental trials on the engine test bed or by means of thermodynamic simulations of the engine cycle. In this work, instead, the authors developed, under some simplifying hypothesis, an original theoretical formulation for the estimation of the optimal combustion phase. The most significant parameters involved with the combustion phase are taken into consideration; in particular, the influence of the combustion duration, of the heat release law, of the heat transfer to the combustion chamber walls, and of the mechanical friction losses is evaluated. The theoretical conclusion, experimentally proven by many authors, is that the central point of the combustion phase (known as the location of the 50% of mass fraction burnt, here called MFB50) must be delayed with respect to the top dead center as a consequence of both heat exchange between gas and chamber walls and friction losses.Keywords
This publication has 6 references indexed in Scilit:
- A Comparison Between Combustion Phase Indicators for Optimal Spark TimingJournal of Engineering for Gas Turbines and Power, 2008
- Thermal modelling of modern engines: A review of empirical correlations to estimate the in-cylinder heat transfer coefficientProceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering, 2006
- Temperature and air–fuel ratio dependent specific heat ratio functions for lean burned and unburned mixtureEnergy Conversion and Management, 2005
- Engine Control Using Cylinder Pressure: Past, Present, and FutureJournal of Dynamic Systems, Measurement, and Control, 1993
- Engine Control Methods Using Combustion Pressure FeedbackSAE International Journal of Advances and Current Practices in Mobility, 1989
- A New Approach to Evaluate Instantaneous Friction and Its Components in Internal Combustion EnginesSAE International Journal of Advances and Current Practices in Mobility, 1984