The Impact Resistance of Highly Densified Metal Alloys Manufactured from Gas-Atomized Pre-Alloyed Powders
Open Access
Abstract
With the increasing acceleration of three-dimensional (3D) printing (for example, powder bed fusion (PBF)) of metal alloys as an additive manufacturing process, a comprehensive characterization of 3D-printed materials and structures is inevitable. The purpose of this work was to test highly densified materials produced from gas-atomized pre-alloyed metallic powders, namely 316L, Ti6Al4V, AlSi10Mg, CuNi2SiCr, CoCr28Mo6, and Inconel718, under impact conditions. This was done to demonstrate the best possible performance of such materials. Optimized spark plasma sintering (SPS) parameters (pressure, temperature, heating rate, and holding time) are applied as a novel technique of powder metallurgy. The densification level, impact site (imprint) diameter and volume, and Vickers hardness were studied. The comparison of 316L stainless steel (1) sintered by the SPS process, (2) manufactured by PBF process, and (3) coated by the physical vapor deposition (PVD) process (thin layer of TiAlN) was successfully achieved.Keywords
This publication has 30 references indexed in Scilit:
- Selective laser manufacturing of Ti-based alloys and composites: impact of process parameters, application trends, and future prospectsMaterials Today Advances, 2020
- Perspectives of metal-diamond composites additive manufacturing using SLM-SPS and other techniques for increased wear-impact resistanceInternational Journal of Refractory Metals and Hard Materials, 2020
- Mechanical Behavior of Ti6Al4V Scaffolds Filled with CaSiO3 for Implant ApplicationsApplied Sciences, 2019
- Comparison of Mechanical and Antibacterial Properties of TiO2/Ag Ceramics and Ti6Al4V-TiO2/Ag Composite Materials Using Combined SLM-SPS TechniquesMetals, 2019
- Additive manufacturing (3D printing): A review of materials, methods, applications and challengesComposites Part B: Engineering, 2018
- On Joule heating during spark plasma sintering of metal powdersScripta Materialia, 2014
- Additive manufacturing and its societal impact: a literature reviewThe International Journal of Advanced Manufacturing Technology, 2012
- Spark Plasma Sintering of Metals and Metal Matrix Nanocomposites: A ReviewJournal of Nanomaterials, 2012
- Ductility of a Ti‐6Al‐4V alloy produced by selective laser melting of prealloyed powdersRapid Prototyping Journal, 2010
- Densification behavior of gas and water atomized 316L stainless steel powder during selective laser meltingApplied Surface Science, 2010