ASAP7 predictive design kit development and cell design technology co-optimization: Invited paper
Authors:
- 1 November 2017
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 992-998
Abstract
This work discusses the ASAP7 predictive process design kit (PDK) and associated standard cell library. The necessity for multi-patterning (MP) techniques at advanced nodes results in the standard cell and SRAM architecture becoming entangled with design rules, mandating design-technology co-optimization (DTCO). This paper discusses the DTCO process involving standard cell physical design. An assumption of extreme ultraviolet (EUV) lithography availability in the PDK allows bi-directional M1 geometries that are difficult with MP. Routing and power distribution schemes for self-aligned quadruple patterning (SAQP) friendly, high density standard cell based blocks are shown. Restrictive design rules are required and supported by the automated place and route (APR) setup. Supporting sub-20 nm dimensions with academic tool licenses is described. The APR (QRC techfile) extraction shows high correlation with the Calibre extraction deck. Finally, use of the PDK for academic coursework and research is discussed.Keywords
This publication has 8 references indexed in Scilit:
- Robust 7-nm SRAM design on a predictive PDK2017
- Design flows and collateral for the ASAP7 7nm FinFET predictive process design kit2017
- Design technology co-optimization of back end of line design rules for a 7 nm predictive process design kit2017
- ASAP7: A 7-nm finFET predictive process design kitMicroelectronics Journal, 2016
- Architectural strategies in standard-cell design for the 7 nm and beyond technology nodeJournal of Micro/Nanolithography, MEMS, and MOEMS, 2016
- FreePDK152015
- 32/28nm Educational Design Kit: Capabilities, deployment and future2013
- FreePDK: An Open-Source Variation-Aware Design Kit2007