Energy Absorption by Foam Filled Structures
Author:
- 1 February 1980
- conference paper
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
Abstract
The energy absorbed during the axial collapse of a variety of structures made in steel, aluminum alloy and glass fiber reinforced plastic is examined with respect to the changes produced by foam filling. A simple-model is devised which permits reasonable estimates of the axial collapse load for a structure and an assessment of the weight effectiveness of foam filling for that structure. Design charts are given, from which the dimensions can be derived for sections made in either steel or aluminum alloys of any particular strength level, in order to establish the weight effectiveness of foam filling. On a weight effectiveness basis, foam filling is primarily of value only in sections made from high density, low strength materials, e.g., mild steel. For mild steel foam filling becomes weight effective in sections having a thickness: section side ratio of less than .02 approximately. In the case of brittle materials, e.g., fiber reinforced plastics, foam filling promotes the crush stability of the structure. Such improvements in this stability may be the major need for foam filling in these sections and also in large, thin-wall metal sections.Keywords
This publication has 10 references indexed in Scilit:
- Energy Absorption by the Structural Collapse of Spot-Welded Sheet Metal SectionsSAE International Journal of Advances and Current Practices in Mobility, 1980
- The collapse of square section tubes in bendingMetallurgical Transactions A, 1979
- Energy absorption by structural collapse in dual phase steel tubesMetallurgical Transactions A, 1979
- Energy Absorption in Composite StructuresJournal of Composite Materials, 1979
- The Interplay of Geometric and Materials Variables in Energy AbsorptionJournal of Engineering Materials and Technology, 1977
- The Effect of Strain-Rate Upon the Tensile Deformation of MaterialsJournal of Engineering Materials and Technology, 1975
- Impact Behaviour of Small Scale Model Motor CoachesProceedings of the Institution of Mechanical Engineers, 1972
- Compression of Cellular Plastics at High Strain RatesJournal of Cellular Plastics, 1971
- Use of collapsible structural elements as impact isolators, with special references to automotive applicationsJournal of Strain Analysis, 1970
- High-velocity deformation properties of polyurethane foamsExperimental Mechanics, 1969