Plasma reactor with continuous flow system for degradation of methylene blue
- 21 September 2018
- conference paper
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 2011 (1) , 020037
Abstract
This study aimed to optimize a plasma reactor with continuous flow system using AC or DC as a voltage source and a pair of stainless steel as needle electrodes with 2±0.005 cm of apart. The electrodes were placed 4±0.5 mm above the methylene blue solution as a sample. The optimization of the reactor evaluated from degradation of methylene blue after contact with plasma for several contact time variation. The flow rate of methylene blue was 8.3 cc/second. The degradation of methylene blue was seen from absorbance, pH, and temperature after contact compare to before contact with the plasma. Generation of plasma occurs at 11.5 kV of DC or AC voltage. Then, absorbance and pH of methylene blue were decreased as increasing of contact time with plasma. However, the temperature of methylene blue is increased. On the flowrate of 8.3 cc/second with the volume of 1000 mL, the absorbance of methylene blue decrease until 99.37% after contact with plasma using DC voltage for 210 minutes. However, using AC voltage it only takes 180 minutes to decrease until 99.72%.Keywords
This publication has 8 references indexed in Scilit:
- Plasma Discharge with Different Electrode Diameters for Reducing Methylene Blue ConcentrationIOP Conference Series: Materials Science and Engineering, 2018
- Water Treatment Using Plasma Discharge with Variation of Electrode MaterialsIOP Conference Series: Materials Science and Engineering, 2018
- United States Service Sector Data2015
- Adsorption of Methylene Blue Dye from Aqueous Solutions by Modified Pumice Stone: Kinetics and Equilibrium StudiesHealth Scope, 2013
- Effect of atmospheric pressure plasma on inactivation of pathogens inoculated onto bacon using two different gas compositionsFood Microbiology, 2011
- Analysis of the degradation mechanism of methylene blue by atmospheric pressure dielectric barrier discharge plasmaChemical Engineering Journal, 2010
- Importance of H2O2/Fe2+ ratio in Fenton's treatment of a carpet dyeing wastewaterJournal of Hazardous Materials, 2006
- Electron Density and Energy Distributions in the Positive DC Corona: Interpretation for Corona-Enhanced Chemical ReactionsPlasma Chemistry and Plasma Processing, 2002