Design of a traveling wave type ultrasonic motor
Authors:
- H. HirataHHH. Hirata
- S. UehaSUS. Ueha
- 1 March 1995
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control
- Vol. 42 (2) , 225-231
Abstract
The purpose of the present paper is to establish a method of design for a traveling wave type ultrasonic motor. This method is based on two models for the ultrasonic motor. A two-dimensional elastic contact model is used for estimating the friction drive between the rotor and vibrator of the motor. Moreover, an electrical equivalent circuit is used to estimate the interaction between the electrical and mechanical parts of the vibrator. The proposed method is applied to the design of a prototype motor. To determine applicability of the method, the load characteristics of the prototype motor are measured. The measured characteristics agree with the required ones which are specified in advance. As a result, the validity of the proposed method is experimentally confirmed.<>Keywords
This publication has 7 references indexed in Scilit:
- Design of a hybrid transducer type ultrasonic motorIEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control, 1993
- Characteristics estimation of a traveling wave type ultrasonic motorIEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control, 1993
- Finite-element analysis of the rotor/stator contact in a ring-type ultrasonic motorIEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control, 1992
- Revolution Speed Characteristics of an Ultrasonic Motor Estimated from the Pressure Distribution of the RotorJapanese Journal of Applied Physics, 1992
- Force factor design of disk vibrators used for ultrasonic motors.Acoustical Science and Technology, 1992
- Piezoelectric Ultrasonic Motor1987
- Rotary Ultrasonic Motor using Extensional Vibration of a RingJapanese Journal of Applied Physics, 1986