Formability Characterization of Fiber Reinforced Polymer Composites Using a Novel Test Method
- 1 October 2021
- journal article
- research article
- Published by ASTM International in Journal of Testing and Evaluation
- Vol. 50 (2) , 1140-1154
Abstract
Fiber reinforced polymer composites are often used as a replacement for metal alloys because of the superior strength to weight ratio. However, a major drawback of these materials is the lack of formability caused by the low strain to failure ratio that does not allow the material to follow tooling contours into deep drawn shapes or tight radii. Composite materials have a multiscale hierarchical structure where micro and meso scale effects (fiber and tow scales) contribute to the macro structural response (laminate scale). In particular, during forming, different deformation occurs simultaneously at every scale. Currently, the amount of quantifiable and comparable forming data for both continuous and discontinuous fiber reinforced polymer composites, including a multi-scale understanding of the deformation response, is limited because of the lack of a testing system. This article proposes a novel test method and an apparatus called “the forming fixture” for testing the tow formability of fiber reinforced polymer composites by determining the required load to form an uncured resin impregnated fiber tow sample into a stretch drawn profile. Test results from forming of Hexcel (Stamford, CT) IM7-G continuous carbon fiber impregnated with Huntsman (The Woodlands, TX) RDM 2019-053 resin system, in the temperature range of 21°C–121°C, are discussed to demonstrate the use of the proposed apparatus including representative data. Results showed consistency and repeatability, validating the reliability of the novel method. The test aided in defining the forming behavior of the material in real time both visually (e.g. sample failure location) and as forming load versus displacement curves. A novel forming metrics, relating the maximum drawing depth with no failure and the maximum forming load, is defined to compare and select different fiber and resin formulations. Widespread adoption of the forming fixture will reduce reliance on a “trial and error” approach during the the forming process.Keywords
Funding Information
- US Army Combat Capabilities Development Command Aviation & Missile Center Technology Development Directorate (Contract number: W911W6-18-0050)
- US Army Combat Capabilities Development Command Aviation & Missile Center Technology Development Directorate (Contract number: W911W6-18-0050)
This publication has 26 references indexed in Scilit:
- Suitable structure of thermosetting CFRP sheet for cold/warm formingInternational Journal of Material Forming, 2015
- In-situ cure monitoring of an out-of-autoclave prepreg: Effects of out-time on viscosity, gelation and vitrificationComposites Science and Technology, 2014
- Aligned Discontinuous Fibre Composites: A Short HistoryJournal of Multifunctional Composites, 2014
- Testing and modelling of material behaviour and formability in sheet metal formingCIRP Annals, 2014
- Multiscale Modeling of Composites: Toward Virtual Testing … and BeyondJOM, 2012
- An engineering point of view about fatigue of polymer matrix composite materialsInternational Journal of Fatigue, 2006
- Carbon fiber reinforced plastics in aircraft constructionMaterials Science and Engineering: A, 2005
- A numerical model of the viscosity of an epoxy prepreg resin systemPolymer Composites, 1999
- Effect of preform shape on buckling of quasi-isotropic thermoplastic composite laminates during sheet formingComposites Manufacturing, 1995
- Influence of the plastic properties of a material on the forming limit diagram for sheet metal in tensionInternational Journal of Mechanical Sciences, 1973