Off-the-Shelf Power Supply-Based Battery/Supercapacitor Emulator for Charger Functionality Testing
- 18 March 2016
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Transportation Electrification
- Vol. 2 (2) , 129-139
Abstract
This paper presents a method of battery/supercapacitor emulator (BSE) rapid prototyping, based on modified off-the-shelf components. Low-cost commercial constant output voltage switching power supply, transformed into an input-voltage-controlled converter, is utilized as emulator power stage. The control over input voltage of the power supply is gained by appropriately altering the voltage feedback branch of the control circuitry. Consequently, it becomes possible to tightly regulate the input voltage of the device according to a predefined current–voltage relation and hence emulate any static and/or dynamic behavior by sensing the input current of the power supply and varying its input voltage appropriately. For battery or supercapacitor emulation, the desired charging characteristics may be either derived from manufacturer provided datasheet, obtained experimentally or estimated by solving the appropriate electrical equivalent circuit of the emulated storage device. In order to demonstrate the validity of the proposed method, a prototype was designed and built using an off-the-shelf boost dc–dc converter-based low-cost power supply. Dynamic input characteristics of the prototype were experimentally evaluated and two commercial storage devices (namely MR-2791 lithium ion battery and Maxwell BMOD0058-E016-B02 supercapacitor packs) charging sequences were emulated. The resulting I – V input relations were shown to closely resemble the charging behavior of real devices.Keywords
This publication has 45 references indexed in Scilit:
- Near-Real-Time Parameter Estimation of an Electrical Battery Model With Multiple Time Constants and SOC-Dependent CapacitanceIEEE Transactions on Power Electronics, 2014
- Adaptive Nonlinear Model-Based Fault Diagnosis of Li-Ion BatteriesIEEE Transactions on Industrial Electronics, 2014
- General Analysis and Design Guideline for a Battery Buffer System With DC/DC Converter and EDLC for Electric Vehicles and its Influence on EfficiencyIEEE Transactions on Power Electronics, 2014
- Model-Based Dynamic Power Assessment of Lithium-Ion Batteries Considering Different Operating ConditionsIEEE Transactions on Industrial Informatics, 2013
- Improved Supercapacitor Floating Ageing Interpretation Through Multipore Impedance Model Parameters EvolutionIEEE Transactions on Power Electronics, 2013
- Estimation of State of Charge, Unknown Nonlinearities, and State of Health of a Lithium-Ion Battery Based on a Comprehensive Unobservable ModelIEEE Transactions on Industrial Electronics, 2013
- Improvement of Dynamic Modeling of Supercapacitor by Residual Charge Effect EstimationIEEE Transactions on Industrial Electronics, 2013
- Comparison, Selection, and Parameterization of Electrical Battery Models for Automotive ApplicationsIEEE Transactions on Power Electronics, 2013
- Accelerated Charge–Discharge Cycling Test and Cycle Life Prediction Model for Supercapacitors in Alternative Battery ApplicationsIEEE Transactions on Industrial Electronics, 2011
- Supercapacitor Characterization and Thermal Modelling With Reversible and Irreversible Heat EffectIEEE Transactions on Power Electronics, 2011