Breaking of the Bancroft rule for multiple emulsions stabilized by a single stimulable polymer
- 30 May 2014
- journal article
- research article
- Published by Royal Society of Chemistry (RSC) in Soft Matter
- Vol. 10 (36) , 7073-7087
Abstract
We investigated emulsions of water and toluene stabilized by (co)polymers consisting of styrene (S) and 2-(dimethylamino)ethyl methacrylate (DMAEMA) monomer units with different compositions and structures such as a PDMAEMA homopolymer, a P(S-co-DMAEMA) random copolymer and various PS-b-PDMAEMA and PS-b-(S-co-DMAEMA) block copolymers. The model system is used to study the fundamental conditions under which the different kinds of polymer-stabilized emulsions (direct oil in water, inverse water in oil and multiple emulsions) are stabilized or destabilized by pH change (at constant temperature). Polymer properties like chain conformation at the toluene–water interface as probed by SANS and neutron reflectivity at the liquid–liquid interface, the oil–water partitioning of the polymer chains (Bancroft's rule of thumb) as determined by UV spectroscopy and interfacial tensions measured by the rising and spinning drop techniques are determined. Overall, results evidence that the curvature sign, as defined by positive and negative values as the chain segments occupy preferentially the water and toluene sides of the interface respectively, reliably predicts the emulsion kind. In contrast, the Bancroft rule failed at foreseeing the emulsion type. In the region of near zero curvature the crossover from direct to inverse emulsions occurs through the formation of either unstable coexisting direct and inverse emulsions (i) or multiple emulsions (ii). The high compact adsorption of the chains at the interface as shown by low interfacial tension values does not allow to discriminate between both cases. However, the toluene–water partitioning of the polymeric emulsifier is still a key factor driving the formation of (i) or (ii) emulsions. Interestingly, the stabilization of the multiple emulsions can be tuned to a large extent as the toluene–water polymer partitioning can be adjusted using quite a large number of physico-chemical parameters linked to polymer architecture like diblock length ratio or polymer total molar mass, for example. Moreover, we show that monitoring the oil–water partitioning aspect of the emulsion system can also be used to lower the interfacial tension at low pH to values slightly higher than 0.01 mN m−1, irrespective of the curvature sign.Keywords
This publication has 51 references indexed in Scilit:
- Advances in fabrication of emulsions with enhanced functionality using structural design principlesCurrent Opinion in Colloid & Interface Science, 2012
- W/O/W emulsions with high internal droplet volume fractionFood Hydrocolloids, 2012
- Emulsion Stabilization, Breaking, and Inversion Depends upon Formulation: Advantage or Inconvenience in Flow AssuranceEnergy & Fuels, 2012
- New cosmetic emulsions for dry skinJournal of Cosmetic Dermatology, 2007
- Multiple emulsions for food useCurrent Opinion in Colloid & Interface Science, 2007
- W/O/W multiple emulsions with diclofenac sodiumEuropean Journal of Pharmaceutics and Biopharmaceutics, 2004
- Amphiphilic polyelectrolyte for stabilization of multiple emulsionsPolymer International, 2003
- Synthesis and aqueous solution properties of near-monodisperse tertiary amine methacrylate homopolymers and diblock copolymersPolymer, 2001
- pH/Temperature-Responsive Polymer Composed of Poly((N,N-dimethylamino)ethyl methacrylate-co-ethylacrylamide)Macromolecules, 1997
- Macroemulsion Stability: The Oriented Wedge Theory RevisitedLangmuir, 1996