Edge effect factor affecting the tribological properties in water of protrusion surface textures on stainless steel
Authors:
Open Access
- 6 June 2018
- journal article
- research article
- Published by Institution of Engineering and Technology (IET) in Biosurface and Biotribology
- Vol. 4 (2) , 46-49
Abstract
Surface textures have been demonstrated to have a positive effect on the friction reduction. However, sharp edges of the normally textured patterns usually cause stress concentration and severe wear during sliding, especially for non‐conformal contacting pairs. In this study, protrusion‐type textures were fabricated at different area ratios on stainless steel discs and edge profiling was performed for the protrusions, and friction tests were conducted in water to investigate the tribological properties. The results show that the friction was reduced markedly by edge profiling due to the formation of wedge contact and improvement of lubricant supply to the contact interfaces under low load. Under high load, severe wear destroyed the wedge contact resulting in high friction as those of the normally textured pairs. High area ratio exhibited better friction reduction effect. The stress analysis via ANSYS indicated that much high stress concentrated at the edges of the protrusions and could be reduced significantly by edge profiling.Keywords
This publication has 11 references indexed in Scilit:
- Laser textured Co-Cr-Mo alloy stored chitosan/poly(ethylene glycol) composite applied on artificial joints lubricationMaterials Science and Engineering: C, 2017
- Global energy consumption due to friction in trucks and busesTribology International, 2014
- Efficiency of laser surface texturing in the reduction of friction under mixed lubricationTribology International, 2014
- Effect of Roller Geometry on Roller Bearing Load–Life RelationTribology Transactions, 2014
- Friction and wear behavior of laser textured surface under lubricated initial point contactWear, 2011
- Improved Tribological Behavior of DLC Films Under Water Lubrication by Surface TexturingTribology Letters, 2010
- Optimization of the surface texture for silicon carbide sliding in waterApplied Surface Science, 2006
- Effect of Deterministic Asperity Geometry on Hydrodynamic LubricationJournal of Tribology, 2004
- Influence of surface texture on boundary lubricated sliding contactsTribology International, 2003
- Characteristics of hydrostatic bearing/seal parts for water hydraulic pumps and motors. Part 1: Experiment and theoryTribology International, 2002