Injection Molding of Zirconia Ceramics Using Water-Soluble Binder
Authors:
- 1 April 2007
- journal article
- Published by Trans Tech Publications, Ltd. in Key Engineering Materials
- Vol. 336-338, 1017-1020
Abstract
Water-soluble binder based injection molding of submicrometer-sized and stabilized zirconia was reported in this paper. The binder phase is chosen as the mixtures of polyethylene glycol, high-density polyethylene, polyvinyl butyral and stearic acid. Binder removal is accomplished by a two-steped process. The water-soluble constituent is firstly removed by dissolution in the water and the remaining is removed through the followed thermal treatment. The apparent viscosities of different kinds of feedstock were tested. The influences of water-leaching time and temperature on the efficiency of PEG removal were discussed.Keywords
This publication has 2 references indexed in Scilit:
- Injection Moulding of 316L Stainless Steel Powder Using Novel Binder SystemPowder Metallurgy, 1995
- Injection molding of submicrometer zirconia: blend formulation and rheologyCeramics International, 1994