On the influence of the exciton-blocking layer on the organic multilayer cells properties
Authors:
- 17 May 2010
- journal article
- research article
- Published by EDP Sciences in The European Physical Journal Applied Physics
- Vol. 50 (3) , 30403
Abstract
The performances of organic photovoltaic cells based on the layer couple electron donor/electron acceptor (ED/EA) are significantly improved when an exciton blocking layer (EBL) is inserted between the organic acceptor and the cathode. A new material, the (Z)-5-(4-chlorobenzylidene)-3-(2-ethoxyphenyl)-2-thioxothiazolidin-4-one, that we called (CBBTZ), has been synthesized, characterized and probed as EBL. The energy levels corresponding to the highest occupied molecular orbital (HOMO) and the lowest unoccupied molecular orbital (LUMO) of the CBBTZ have been determined from the first oxidation and reduction potential respectively, using cyclic voltametric (CV) measurements. From CV curves, CBBTZ in dichloromethane showed a one electron reversible reduction and oxidation waves. The values of its HOMO and LUMO have been estimated to be 6.42 eV and 3.42 eV respectively. Such values show that CBBTZ could be probed as EBL in organic solar cells based on the ED/EA couple copper phthalocyanine(CuPc)/fullerene (C60). The photovoltaic solar cells have been obtained by sequential deposition under vacuum of the different films. The different thin film thicknesses were measured in situ by a quartz monitor. Multilayer solar cells ITO/Au/CuPc/C60/EBL/Al have been probed, where EBL is the aluminium tris(8-hydroxyquinoline) (Alq3), the CBBTZ, the 2-(4-byphenylyl)-5-(4-tert-buthylphenyl)-1,3,4-oxadiazole (butyl PBD) or the bathocuproine (BCP). The optimum film thickness is 8–9 nm whatever the EBL used. When obtained in the same run, the averaged efficiency of the cells using the CBBTZ is of the same order of magnitude than that obtained with BCP and higher than that achieved with Alq3 or butyl PBD. It is shown by XPS study that some aluminium of the cathode is present in the buffer layer. This aluminium could justify the ability of the electrons to cross the insulating exciton blocking layer thick of 9 nm.Keywords
This publication has 17 references indexed in Scilit:
- Energy‐Level Alignment at Organic/Metal and Organic/Organic InterfacesAdvanced Materials, 2009
- Ultra-thin metal layer passivation of the transparent conductive anode in organic solar cellsSolar Energy Materials and Solar Cells, 2008
- Improvement of organic solar cell performances using a zinc oxide anode coated by an ultrathin metallic layerApplied Physics Letters, 2008
- Optimisation of the interface “organic material/aluminium” of CuPc/C60based photovoltaic cellsThe European Physical Journal Applied Physics, 2007
- Investigation into effects of electron transporting materials on organic solar cells with copper phthalocyanine/C60 heterojunctionsChemical Physics Letters, 2006
- Small-molecule organic solar cells with improved stabilityChemical Physics Letters, 2005
- Organic Double‐Heterostructure Photovoltaic Cells Employing Thick Tris(acetylacetonato)ruthenium(III) Exciton‐Blocking LayersAdvanced Materials, 2005
- Efficient photon harvesting at high optical intensities in ultrathin organic double-heterostructure photovoltaic diodesApplied Physics Letters, 2000
- Easy-to-Make Ag/AgCl Reference ElectrodeJournal of Chemical Education, 2000
- Preparation and Properties of Transparent ConductorsMRS Proceedings, 1996