Mode I and mixed mode fracture of polysilicon for MEMS
Authors:
Open Access
- 9 January 2007
- journal article
- Published by Wiley in Fatigue & Fracture of Engineering Materials & Structures
- Vol. 30 (1) , 21-31
Abstract
An experimental study was carried out to investigate the local and effective fracture behaviour of polycrystalline silicon for microelectromechanical systems (MEMS). The apparent mode I critical stress intensity factor was determined from MEMS‐scale tension specimens containing atomically sharp edge pre‐cracks, while local deformation fields were recorded near the crack tip, with high resolution by the in situ Atomic Force Microscopy (AFM)/Digital Image Correlation (DIC) method previously developed by this group. The effective mode I critical stress intensity factor varied in the range 0.843–1.225 MPa√m. This distribution of values was attributed to local (in grain) cleavage anisotropy and to enhanced grain boundary toughening. The same sources resulted in very different local and macroscopic (apparent) stress intensity factors, which, combined with the small grain size of polysilicon (0.3 μm,) were the reason for subcritical crack growth that was evidenced experimentally by AFM topographic and AFM/DIC displacement measurements. The effect of local in‐grain anisotropy and granular inhomogeneity was stronger under mixed mode loading of edge cracks inclined at angles up to 55° with respect to the applied far‐field load. The KI–KII locus was characterized by scatter in the KIc values but on average it followed the curves calculated by the maximum tensile stress and the maximum energy release rate criteria calculated assuming isotropy.Keywords
This publication has 24 references indexed in Scilit:
- Young's modulus, Poisson's ratio and failure properties of tetrahedral amorphous diamond-like carbon for MEMS devicesJournal of Micromechanics and Microengineering, 2005
- Mechanics of Thin Films and MicrodevicesIEEE Transactions on Device and Materials Reliability, 2004
- The mechanical strength of polysilicon films: Part 2. Size effects associated with elliptical and circular perforationsJournal of the Mechanics and Physics of Solids, 2003
- Fracture of polycrystalline siliconMaterials Science and Engineering: A, 2003
- Finite Element Methods for Linear Elastic Fracture Mechanics2003
- A new microtensile tester for the study of MEMS materials with the aid of atomic force microscopyExperimental Mechanics, 2002
- Hardness and fracture toughness of semiconducting materials studied by indentation and erosion techniquesMaterials Science and Engineering: A, 1988
- The influence of geometry of edge-cracked plates on KIand KIIcomponents of the stress intensity factor, studied by causticsJournal of Physics D: Applied Physics, 1984
- An experimental investigation into dynamic fracture: II. Microstructural aspectsInternational Journal of Fracture, 1984
- Associated path independent J-integrals for separating mixed modesJournal of the Mechanics and Physics of Solids, 1983