Dispersion-Minimized Rod and Tube Dielectric Waveguides at $W$ -Band and $D$ -Band Frequencies
- 12 June 2018
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Microwave and Wireless Components Letters
- Vol. 28 (7) , 555-557
Abstract
For multigigabit communication links, dielectric waveguides (DWGs) are a cost-efficient alternative to conventional transmission lines such as (coaxial or paired) copper cables or optical fibers. The DWG can be optimized in different ways: optimization can be done for low attenuation or low dispersion to increase the data rate and link distance or for high guiding behavior to realize small bending radii. In this letter, dispersion minimization of DWGs with a circular cross section is investigated. An analytical approach is used to calculate the waveguide dispersion of rod and tube DWGs for different combinations of outer and inner diameters as well as different materials at W-band and D-band frequencies. As a result, design guidelines for dispersion-minimized DWGs are presented. Finally, a dispersion-minimized tubular DWG was realized and measured to prove the results of the optimization.Keywords
This publication has 8 references indexed in Scilit:
- Loss and Dispersion Limitations in mm-Wave Dielectric Waveguides for High-Speed LinksIEEE Transactions on Terahertz Science and Technology, 2016
- Dielectric permittivity determination in W-band with dielectric ring resonators2016
- A 90-GHz receiver in 40-nm CMOS for plastic waveguide linksAnalog Integrated Circuits and Signal Processing, 2015
- High-Speed mm-Wave Data-Link Based on Hollow Plastic Cable and CMOS TransceiverIEEE Microwave and Wireless Components Letters, 2013
- A versatile multi-modality serial link2012
- A 12.5+12.5 Gb/s Full-Duplex Plastic Waveguide InterconnectIEEE Journal of Solid-State Circuits, 2011
- The Essence of Dielectric Waveguides2008
- Low-index discontinuity terahertz waveguidesOptics Express, 2006