A generalized multi-pass machining model for machining parameter selection in turning
Authors:
- 1 May 1995
- journal article
- research article
- Published by Taylor & Francis in International Journal of Production Research
- Vol. 33 (5) , 1467-1487
Abstract
A machining parameter selection model has been developed using multi-pass turning operation as a general type. An approximation optimization solution approach has been defined for this machining model. This model is a constrained model with the objective of achieving minimum cost. Depth-of-cut and number-of-pass are considered as variables in the model. All parameters, including the number-of-passes, cutting speed, feed rate and depth-of-cut for each pass, reach optimal simultaneously in one stage. The performance of this machining parameter optimization model is examined using a example, and the results are compared with current publications that provide same input data.Keywords
This publication has 14 references indexed in Scilit:
- Optimization of Multistage Machining Systems, Part 1: Mathematical SolutionJournal of Engineering for Industry, 1992
- The Optimization of Machining Operations Based on a Combined Criterion, Part 1: The Use of Combined Objectives in Single-Pass OperationsJournal of Engineering for Industry, 1992
- Analysis of optimal machining conditions for flow-type automated manufacturing systemsInternational Journal of Production Research, 1991
- A Sequential Linearization Approach for Solving Mixed-Discrete Nonlinear Design Optimization ProblemsJournal of Mechanical Design, 1991
- Sequence of operations optimization in single-stage multifunctional systemsJournal of Manufacturing Systems, 1991
- Analysis of optimal machining speeds for automatic manufacturingInternational Journal of Production Research, 1989
- Optimization of Multipass Turning With ConstraintsJournal of Engineering for Industry, 1981
- Optimization of the Constrained Machining Economics Problem by Geometric ProgrammingJournal of Engineering for Industry, 1971
- Regression Analysis for Predicting Surface Finish and Its Application in the Determination of Optimum Machining ConditionsJournal of Engineering for Industry, 1970
- A Nonlinear Programming Technique for the Optimization of Continuous Processing SystemsManagement Science, 1961