Radial basis functional model for multi-objective sheet metal forming optimization
- 28 June 2011
- journal article
- research article
- Published by Taylor & Francis in Engineering Optimization
- Vol. 43 (12) , 1351-1366
Abstract
Fracture and wrinkling are two major defects in sheet metal forming and can be eliminated via an appropriate drawbead design. This article proposes to adopt a multi-objective particle swarm optimization (MOPSO) approach, which differs from traditional multi-objective optimization with construction of a single cost function. MOPSO shows a certain advantage over other single cost function or population-based algorithms. While radial basis function (RBF) has shown considerable promise in highly non-linear problems, there has been no report in sheet metal forming design. Here RBF is attempted to establish the metamodels for fracture and wrinkling criteria in sheet metal forming design. In this article, a sophisticated automobile inner stamping case is exemplified, which demonstrated that RBF provides a better surrogate accuracy and MOPSO is more effective than the other methods studied. The use of RBF driven MOPSO procedure significantly improved the formability and can be recommended for sheet metal process design.Keywords
This publication has 55 references indexed in Scilit:
- Crashworthiness design for functionally graded foam-filled thin-walled structuresMaterials Science and Engineering: A, 2010
- Effect of technological parameter on the process performance for electric discharge milling of insulating Al2O3 ceramicJournal of Materials Processing Technology, 2008
- Optimization of sheet metal forming processes by adaptive response surface based on intelligent sampling methodJournal of Materials Processing Technology, 2008
- Automated design methodology for automobile side panel die using an effective optimization approachMaterials & Design (1980-2015), 2007
- Moving least squares response surface approximation: Formulation and metal forming applicationsComputers & Structures, 2005
- Optimization of draw-in for an automotive sheet metal partJournal of Materials Processing Technology, 2005
- Development of optimum process design system for sheet fabrication using response surface methodJournal of Materials Processing Technology, 2003
- Recent developments on the analysis and optimum design of sheet metal forming parts using a simplified inverse approachComputers & Structures, 2000
- Optimization of a sheet metal forming process using successive multipoint approximationsStructural and Multidisciplinary Optimization, 1999
- Bead pattern optimizationStructural and Multidisciplinary Optimization, 1996