Solid flow in the annular region of a spouted bed
Authors:
- 1 August 1989
- journal article
- research article
- Published by Wiley in AIChE Journal
- Vol. 35 (8) , 1328-1336
Abstract
The solid circulation in the annular region of a 0.146 and a 0.292 m ID semicylindrical and cylindrical air spouted beds was investigated for different spouting conditions. Stroboscopic photography, stopwatch and fiber optic methods were used to measure the vertical particle velocities in the annular region. The optical fiber probe enabled the measurement of particle velocities inside the dense annular phase and was validated at the walls. Velocity profiles in half beds were very different from those found in full beds. The work was then limited to full beds. Experimental results show that the solids flow is characterized by a point sink at the nozzle entrance with the solids moving almost in plug flow higher in the bed. There is negligible entrainment of solids along the spout wall and slow, thin wall layers are observed near the walls and spout. The velocity profiles are independent of the total height of the bed. A kinematic model successfully describes the observed velocity field.Keywords
This publication has 19 references indexed in Scilit:
- An experimental study of spouting in large sector bedsThe Canadian Journal of Chemical Engineering, 1983
- Optical fiber probe transit anemometer for particle velocity measurements in fluidized bedsAIChE Journal, 1982
- A comparison of spouting and jetting in round and half‐round fluidized bedsThe Canadian Journal of Chemical Engineering, 1981
- A comparison of cylindrical and semi-cylindrical spouted beds of coarse particlesChemical Engineering Science, 1980
- A theory for effective solid stresses in the annulus of a spouted bedThe Canadian Journal of Chemical Engineering, 1979
- Fluid flow pattern, minimum spouting velocity and pressure drop in spouted bedsThe Canadian Journal of Chemical Engineering, 1976
- Motion of solids in spouted bedsThe Canadian Journal of Chemical Engineering, 1974
- Prediction of spout diameter in a spouted bed—A theoretical modelPowder Technology, 1972
- A theory of the kinematics of ideal soils under plane strain conditionsJournal of the Mechanics and Physics of Solids, 1964
- An analysis of air and solid flow in a spouted wheat bedThe Canadian Journal of Chemical Engineering, 1959