Design and Implementation of an Optimized Printed Circuit Board Axial-Flux Permanent Magnet Machine
- 23 August 2020
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 1, 111-116
Abstract
Although axial-flux machines are used in a different variety of applications, production challenge of the stator winding is a limiting factor for more widely use of these machines. Printed circuit board winding (PCB) can mitigate the production challenges of the axial-flux machines by introducing cheap and precise mass production capabilities. In this paper, the design and implementation of an 16 pole, 2000 RPM, 40 W axial-flux permanent magnet machine with PCB winding for gimbal camera stabilization system used in aviation industry is presented. The machine’s flux density, induced voltage, number of turns and some other parameters are analytically calculated. Parameters are optimized using a genetic optimization algorithm. The design with highest torque density value is validated by an finite element analysis tool, ANSYS Maxwell. Finally, the prototype is tested at 2000 RPM. In order to check the machine can take the thermal stress, it was put under the full load and the temperature level is recorded. The temperature of the windings did not exceed $45 \mathrm{C}^{\circ}$ under full-load. The efficiency of the motor is found as 72%. Expectations are met by analytical, FEA and test results.
Keywords
This publication has 18 references indexed in Scilit:
- Optimal Design of an Axial-Flux Permanent-Magnet Motor for an Electric Vehicle Based on Driving ScenariosEnergies, 2016
- Dynamic eccentricity in single-rotor single-stator axial flux permanent magnet synchronous machine with parallel path windings2015
- A Review of Recent Developments in Electrical Machine Design Optimization Methods With a Permanent-Magnet Synchronous Motor Benchmark StudyIEEE Transactions on Industry Applications, 2013
- Design and analysis of an axial-field permanent magnet generator with multiple stators and rotors2011
- A Novel Axial Flux Permanent-Magnet Machine for Flywheel Energy Storage System: Design and AnalysisIEEE Transactions on Industrial Electronics, 2010
- Test and Simulation of Axial Flux-Motor Characteristics for Hybrid Electric VehiclesIEEE Transactions on Vehicular Technology, 2004
- Development of an axial-gap spindle motor for computer hard disk drives using PCB winding and dual air gapsIEEE Transactions on Magnetics, 2002
- An axial-flux permanent-magnet generator for a gearless wind energy systemIEEE Transactions on Energy Conversion, 1999
- Modular, axial-flux, permanent-magnet motor for ship propulsion drives1997
- Design and construction of a wheel-directly-coupled axial-flux PM motor prototype for EVs1994