Microstructure, mechanical, and rheological properties of natural rubber/ethylene propylene diene monomer nanocomposites reinforced by multi‐wall carbon nanotubes
- 17 August 2016
- journal article
- research article
- Published by Wiley in Polymer Composites
- Vol. 39 (S2) , E745-E753
Abstract
Nanocomposites based on natural rubber (NR)/ethylene propylene diene monomer (EPDM)/multi‐wall carbon nanotubes (MWCNT) have been prepared in an internal and a two roll‐mill mixer in two steps. The effect of carbon nanotubes (MWCNTs) and rubber composition were studied on microstructure, mechanical and rheological properties of the vulcanizated NR/EPDM/MWCNT nanocomposites. Ethylene propylene diene monomer grafted with maleic anhydride (EPDM‐g‐MAH) was prepared using a solution process. Grafting of maleic anhydride on EPDM confirmed by attenuated total reflection Fourier transform infrared spectroscopy (ATR‐FTIR). The effects of compatibilizer (EPDM‐g‐MAH) and functionalized carbon nanotubes (f‐MWCNTs) on mechanical properties of NR/EPDM/MWCNT nanocomposites was investigated as well. Dynamic mechanical thermal analysis (DMTA) results demonstrated the glass transition temperature (Tg) of nanocomposites were slowly enhanced with increasing the amount of MWCNTs. The microstructure of nanocomposites have been characterized using scanning electron microscopy (SEM) and transmission electron microscopy (TEM), which showed that the observed MWCNTs were in both NR and EPDM phases. The rheological behavior has been evaluated by a rubber processing analyzer (RPA). The ozone resistance times of the nanocomposite samples indicated that by increasing the amount of MWCNTs ozone resistance was improved. POLYM. COMPOS., 39:E745–E753, 2018. © 2016 Society of Plastics EngineersKeywords
This publication has 39 references indexed in Scilit:
- Morphology and properties of NR/EPDM rubber blends filled with small amounts of titania nanoparticlesPolymer Composites, 2011
- Design and evaluation of the interface between carbon nanotubes and natural rubberPolymer Composites, 2010
- Preparation, characterization, and physical properties of multiwall carbon nanotube/elastomer compositesPolymer Engineering & Science, 2009
- Preparation and properties of poly (p-phenylene sulfide)/multiwall carbon nanotube composites obtained by melt compoundingComposites Science and Technology, 2009
- Processing and Material Characteristics of a Carbon‐Nanotube‐Reinforced Natural RubberMacromolecular Materials and Engineering, 2007
- Evaluation of new conducting polymeric membrane based on sulfonation of compatibilized NR/EPDM blendJournal of Applied Polymer Science, 2007
- Synthesis and Characteristics of MAH-g-EPDM Compatibilized EPDM/NBR Rubber BlendsJournal of Elastomers & Plastics, 2006
- Carbon Nanotubes Reinforced Nylon-6 Composite Prepared by Simple Melt-CompoundingMacromolecules, 2003
- Rheological properties and compatibility of NR/EPDM and NR/brominated EPDM blendsJournal of Applied Polymer Science, 2003
- Maleic Anhydride Grafting on EPDM: Qualitative and Quantitative DeterminationJournal of the Brazilian Chemical Society, 1999