Noise-Shaping SAR ADC Using a Two-Capacitor Digitally Calibrated DAC With 82.6-dB SNDR and 90.9-dB SFDR
- 27 July 2021
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems I: Regular Papers
- Vol. 68 (10) , 4001-4012
Abstract
A novel active noise-shaping SAR ADC with on- chip digital DAC calibration is presented. To relax the design of the single op-amp used as an integrator, correlated double sampling (CDS) and correlated level shifting (CLS) were implemented. CDS minimizes the offset of the integrator and reduces the flicker noise, while CLS boosts the gain of the op-amp and reduces the power consumption. Also, a two-step incremental ADC based digital DAC calibration scheme was implemented to cancel the DAC mismatch errors and parasitics effects. The ADC was fabricated in 0.13 $\mu \text{m}$ CMOS technology. It achieved 85.1 dB DR, 82.6 dB SNDR and 90.9 dB SFDR within a 2 kHz signal bandwidth with an oversampling ratio OSR = 32. It consumes 40.8 $\mu \text{W}$ power using a 1.6 V power supply.Keywords
Funding Information
- National Science Foundation Center on the Design of Analog and Digital Integrated Circuits
- Semiconductor Research Corporation (2810.011)
This publication has 17 references indexed in Scilit:
- An 11-Bit 250-nW 10-kS/s SAR ADC With Doubled Input Range for Biomedical ApplicationsIEEE Transactions on Circuits and Systems I: Regular Papers, 2017
- A two-capacitor SAR-assisted multi-step incremental ADC with a single amplifier achieving 96.6 dB SNDR over 1.2 kHz BW2017
- An Oversampling SAR ADC With DAC Mismatch Error Shaping Achieving 105 dB SFDR and 101 dB SNDR Over 1 kHz BW in 55 nm CMOSIEEE Journal of Solid-State Circuits, 2016
- Nested-Current-Mirror Rail-to-Rail-Output Single-Stage Amplifier With Enhancements of DC Gain, GBW and Slew RateIEEE Journal of Solid-State Circuits, 2015
- A 9.35-ENOB, 14.8 fJ/conv.-step fully-passive noise-shaping SAR ADC2015
- Noise‐shaping SAR ADC using three capacitorsElectronics Letters, 2013
- Analysis of Power Consumption and Linearity in Capacitive Digital-to-Analog Converters Used in Successive Approximation ADCsIEEE Transactions on Circuits and Systems I: Regular Papers, 2011
- An Over-60 dB True Rail-to-Rail Performance Using Correlated Level Shifting and an Opamp With Only 30 dB Loop GainIEEE Journal of Solid-State Circuits, 2008
- Analysis of switched-capacitor common-mode feedback circuitIEEE Transactions on Circuits and Systems II: Analog and Digital Signal Processing, 2003
- Circuit techniques for reducing the effects of op-amp imperfections: autozeroing, correlated double sampling, and chopper stabilizationProceedings of the IEEE, 1996