A Contribution to Improve the Accuracy of Chatter Prediction in Machine Tools Using the Stability Lobe Diagram
- 3 January 2014
- journal article
- Published by ASME International in Journal of Manufacturing Science and Engineering
- Vol. 136 (2) , 021005
Abstract
The chatter phenomenon can severely limit the power available for milling. The stability lobe diagram (SLD) is a very fast and simple method to predict the chatter free zone, allowing the selection of the most adequate spindle speed and depth of cut for higher productivity. However, the data used to calculate the SLD, coming from frequency response functions (FRFs), must be acquired adequately to improve the predictability. FRFs result differently depending on the activation of the spindle electronic control. The present work uses SLDs to investigate these differences and experimental end milling tests to assess the accuracy of SLDs curves. Results indicate that the inclusion of spindle electronic control provides better accuracy in predicting the chatter in milling.Keywords
This publication has 21 references indexed in Scilit:
- Chatter in machining processes: A reviewInternational Journal of Machine Tools and Manufacture, 2011
- Optimization of multiple tuned mass dampers to suppress machine tool chatterInternational Journal of Machine Tools and Manufacture, 2010
- The effect of serration on mechanics and stability of milling cuttersInternational Journal of Machine Tools and Manufacture, 2010
- A new experimental methodology for identification of stability lobes diagram in milling operationsInternational Journal of Machine Tools and Manufacture, 2008
- Modeling of spindle-bearing and machine tool systems for virtual simulation of milling operationsInternational Journal of Machine Tools and Manufacture, 2007
- Modeling and identification of tool holder–spindle interface dynamicsInternational Journal of Machine Tools and Manufacture, 2007
- Model-based chatter stability prediction for high-speed spindlesInternational Journal of Machine Tools and Manufacture, 2007
- Milling machine spindle analysis using FEM and non-contact spindle excitation and response measurementInternational Journal of Machine Tools and Manufacture, 2007
- Vibration absorbers for chatter suppression: A new analytical tuning methodologyJournal of Sound and Vibration, 2007
- Expert spindle design systemInternational Journal of Machine Tools and Manufacture, 2005