Thin-film piezoelectric-on-silicon resonators for high-frequency reference oscillator applications
Authors:
- Reza AbdolvandRAReza Abdolvand
- Gavin K. HoGHGavin K. Ho
Top Cited Papers
- 30 December 2008
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control
- Vol. 55 (12) , 2596-2606
Abstract
This paper studies the application of lateral bulk acoustic thin-film piezoelectric-on-substrate (TPoS) resonators in high-frequency reference oscillators. Low-motional impedance TPoS resonators are designed and fabricated in 2 classes--high-order and coupled-array. Devices of each class are used to assemble reference oscillators and the performance characteristics of the oscillators are measured and discussed. Since the motional impedance of these devices is small, the transimpedance amplifier (TIA) in the oscillator loop can be reduced to a single transistor and 3 resistors, a format that is very power-efficient. The lowest reported power consumption is ~350 muW for an oscillator operating at ~106 MHz. A passive temperature compensation method is also utilized bThis paper studies the application of lateral bulk acoustic thin-film piezoelectric-on-substrate (TPoS) resonators in high-frequency reference oscillators. Low-motionalimpedance TPoS resonators are designed and fabricated in 2 classes--high-order and coupled-array. Devices of each class are used to assemble reference oscillators and the performance characteristics of the oscillators are measured and discussed. Since the motional impedance of these devices is small, the transimpedance amplifier (TIA) in the oscillator loop can be reduced to a single transistor and 3 resistors, a format that is very power-efficient. The lowest reported power consumption is ~350 muW for an oscillator operating at ~106 MHz. A passive temperature compensation method is also utilized by including the buried oxide layer of the silicon-on-insulator (SOI) substrate in the structural resonant body of the device, and a very small (-2.4 ppm/degC) temperature coefficient of frequency is obtained for an 82-MHz oscillator.y including the buried oxide layer of the silicon-on-insulator (SOI) substrate in the structural resonant body of the device, and a very small (-2.4 ppm/degC) temperature coefficient of frequency is obtained for an 82-MHz oscillator.Keywords
This publication has 18 references indexed in Scilit:
- 7E-4 Enhanced Power Handling and Quality Factor in Thin-Film Piezoelectric-on-Substrate ResonatorsIEEE International Ultrasonics Symposium, 2007
- Single-Resonator Dual-Frequency Thin-Film Piezoelectric-on-Substrate Oscillator2007
- High-order composite bulk acoustic resonators2007
- ZNO-on-nanocrystalline diamond lateral bulk acoustic resonators2007
- Micromachined thin film plate acoustic resonators utilizing the lowest order symmetric lamb wave modeIEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control, 2006
- Influence of automatic level control on micromechanical resonator oscillator phase noise2004
- High frequency micromechanical piezo-on-silicon block resonators2004
- Fundamental properties of thin film resonators2002
- Elastic properties of silicon dioxide films deposited by chemical vapour deposition from tetraethylorthosilicateThin Solid Films, 1997
- An analysis of nonlinear resonance in contoured-quartz crystal resonatorsThe Journal of the Acoustical Society of America, 1986