Microstructural and mechanical study of an induction nitrided Ti gr.5 hip prosthesis component
Authors:
- A. LanzuttiA. Lanzutti
- A. RaffaelliARA. Raffaelli
- M. MagnanMMM. Magnan
- L. FedrizziLFL. Fedrizzi
- M. RegisMRM. Regis
- E. MarinE. Marin
- 1 November 2019
- journal article
- research article
- Published by Elsevier in Surface and Coatings Technology
- Vol. 377
Abstract
No abstract availableKeywords
This publication has 31 references indexed in Scilit:
- Fretting corrosion of CoCrMo and Ti6Al4V interfacesBiomaterials, 2012
- Corrosion fatigue of biomedical metallic alloys: Mechanisms and mitigationActa Biomaterialia, 2012
- Properties of nitrided layers formed during plasma nitriding of commercially pure Ti and Ti–6Al–4V alloySurface and Coatings Technology, 2012
- Tailoring of microstructure and mechanical properties of Ti–6Al–4V with local rapid (induction) heat treatmentMaterials Science and Engineering: A, 2011
- Studies on the corrosion and wear behavior of the laser nitrided biomedical titanium and its alloysMaterials Science and Engineering: C, 2010
- Diffusion treatment of Ni–B coatings by induction heating to harden the surface of Ti–6Al–4V alloyMaterials Chemistry and Physics, 2009
- Surface hardening of biomedical Ti–29Nb–13Ta–4.6Zr and Ti–6Al–4V ELI by gas nitridingMaterials Science and Engineering: A, 2008
- Enhancing the microstructure and properties of titanium alloys through nitriding and other surface engineering methodsSurface and Coatings Technology, 2005
- Review of wear mechanisms in hip implants: Paper I – GeneralMaterials & Design (1980-2015), 2004
- Titanium nitride coatings on surgical titanium alloys produced by a powder immersion reaction assisted coating method: residual stresses and fretting behaviorSurface and Coatings Technology, 2000