Selective etching of GaN over AlN using an inductively coupled plasma and an O2/Cl2/Ar chemistry
Authors:
- 1 May 2000
- journal article
- Published by American Vacuum Society in Journal of Vacuum Science & Technology A
- Vol. 18 (3) , 879-881
Abstract
An alternative method for achieving etching selectivity between GaN and AlN has been demonstrated. The etch rate of AlN was significantly decreased by the addition of a low concentration of to a –Ar mixture in an inductively coupled plasma (ICP) etching system. The etch rate of GaN in the -containing plasma was approximately 15% less than the plasma without the for the same parameters. The pressure and the ICP power were varied to achieve a maximum selectivity of 48 at a pressure of 10 mTorr, a direct current bias of −150 V, and an ICP power of 500 W. The etch rates of GaN and AlN at these parameters were 4800 and 100 Å/min, respectively.
Keywords
This publication has 7 references indexed in Scilit:
- A GaN/4H-SiC heterojunction bipolar transistor with operation up to 300°CMRS Internet Journal of Nitride Semiconductor Research, 1999
- Analysis of reactor geometry and diluent gas flow effects on the metalorganic vapor phase epitaxy of AIN and GaN thin films on α(6H)-SiC substratesJournal of Electronic Materials, 1998
- High rate and selective etching of GaN, AlGaN, and AlN using an inductively coupled plasmaApplied Physics Letters, 1997
- Electron Cyclotron Resonance Plasma Etching of AlGaN in Cl2/Ar and BCl3/Ar PlasmasJournal of the Electrochemical Society, 1997
- Selective Dry Etching of III‐V Nitrides in Cl2 / Ar , CH 4 / H 2 / Ar , ICl/Ar, and IBr/ArJournal of the Electrochemical Society, 1996
- ICl/Ar electron cyclotron resonance plasma etching of III–V nitridesApplied Physics Letters, 1996
- Growth, Doping and Characterization of AlxGa1−xN Thin Film Alloys on 6H-SiC(0001) SubstratesMRS Internet Journal of Nitride Semiconductor Research, 1996