Effects of B-containing composite flux on the microstructures and mechanical properties of ADC12 alloys
- 8 July 2019
- journal article
- research article
- Published by IOP Publishing in Materials Research Express
- Vol. 6 (9) , 096576
Abstract
The effects of B-containing composite flux on microstructures and mechanical properties of ADC12 alloys were investigated by OM, XRD, SEM and EDS. The results show that when added the B-containing composite flux in ADC12 alloys and the mass ratio of Na2B4O7 and KBF4 in flux is 1:1, the morphology of iron-rich phase transformed from needle-like to less-detrimental Chinese script, the average length of eutectic silicon reduces to the minimum of 22.15 μm at holding time of 90 min. Meanwhile, the iron removal rate, yield strength, ultimate tensile strength and elongation of alloys reach the maximum, 28.7%, 159.12 MPa, 222.08 MPa and 1.76%, respectively. The improvement of mechanical properties is mainly attributed to the transformation of iron-rich phase from needle-like β-Al5FeSi to less-detrimental Chinese script α-AlFe(Mn)Si, Fe reduction and decrease in the length of the eutectic silicon. X-ray diffraction analysis indicated that AlB2 and Fe2B can be formed after the addition of composite flux. The mechanism of purification process was also discussed.Keywords
Funding Information
- Jiangsu Provence Scientific and Technological Achievements Transformation Project (BA2016039)
- top six talent project of Jiangsu province (2014-XCL-005)
- Suzhou science and technology development project (SGC201534)
- National Key R&D Program of China (2016YFB0301000)
This publication has 27 references indexed in Scilit:
- Effects of scandium addition on iron-bearing phases and tensile properties of Al–7Si–0.6Mg alloysMaterials Science and Engineering: A, 2014
- Influence of Ce and Mn addition on α-Fe morphology in recycled Al-Si alloy ingotsInternational Journal of Minerals, Metallurgy and Materials, 2013
- Nanostructured aluminium alloys produced by severe plastic deformation: New horizons in developmentMaterials Science and Engineering: A, 2013
- Effects of rare earth Er additions on microstructure development and mechanical properties of die-cast ADC12 aluminum alloyJournal of Alloys and Compounds, 2012
- Removal of Iron From Aluminum: A ReviewMineral Processing and Extractive Metallurgy Review, 2012
- Feasibility of semi-solid die casting of ADC12 aluminum alloyTransactions of Nonferrous Metals Society of China, 2010
- The influence of cooling rate and manganese content on the β-Al5FeSi phase formation and mechanical properties of Al–Si-based alloysMaterials Science and Engineering: A, 2008
- Effects of Na2B4O7 on the elimination of iron from aluminum meltScripta Materialia, 2007
- The effect of iron and manganese on the formation of intermetallic compounds in aluminum–silicon alloysMaterials Science and Engineering: A, 2004
- Iron intermetallic phases in the Al corner of the Al-Si-Fe systemMetallurgical and Materials Transactions A, 2003