Geometrical Inhomogeneities as Cause of Mechanical Failure in Commercial 18650 Lithium Ion Cells
Open Access
- 12 November 2019
- journal article
- research article
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 166 (15) , A3745-A3752
Abstract
The mechanical degradation of 18650 lithium ion cells is studied by X-ray computed tomography and is correlated to the electrochemical performance. A method for the geometrical analysis of electrodes by computer tomography is developed and applied to charged and discharged cells. As shown in earlier studies, the geometry of the jelly roll is inhomogeneous leading to mechanical stress during charge/discharge cycles. This effect leads to significant deformations of the jelly roll, which can be analyzed by computed tomography. The detailed analysis reveals that expansion of the anode takes place as expected during charging, but the degree of expansion depends on the position within the battery cell: the largest expansion during charging was found within the area of strongest deformations, whereas other areas without any expansion of the jelly roll were also observed. It is reasoned that the observed inhomogeneous expansion/contraction contribute significantly to cell degradation. The strong expansion within the deformed areas leads to sharp bending of the electrodes resulting in delamination of active layers. On the other hand, the absence of anode expansion reflected by a lack of increase in thickness when charging may indicate pore clogging assuming that the additional volume of graphite with intercalated lithium has to be accommodated within the pore structure.Keywords
This publication has 40 references indexed in Scilit:
- Combined cycling and calendar capacity fade modeling of a Nickel-Manganese-Cobalt Oxide Cell with real-life profile validationApplied Energy, 2017
- Temperature dependent ageing mechanisms in Lithium-ion batteries – A Post-Mortem studyJournal of Power Sources, 2014
- A holistic aging model for Li(NiMnCo)O2 based 18650 lithium-ion batteriesJournal of Power Sources, 2014
- A comparative study of commercial lithium ion battery cycle life in electrical vehicle: Aging mechanism identificationJournal of Power Sources, 2014
- A review on lithium-ion battery ageing mechanisms and estimations for automotive applicationsJournal of Power Sources, 2013
- Cycle and calendar life study of a graphite|LiNi1/3Mn1/3Co1/3O2 Li-ion high energy system. Part A: Full cell characterizationJournal of Power Sources, 2013
- Predicting and Extending the Lifetime of Li-Ion BatteriesJournal of the Electrochemical Society, 2013
- Development of a lifetime prediction model for lithium-ion batteries based on extended accelerated aging test dataJournal of Power Sources, 2012
- Electro-thermal battery model identification for automotive applicationsJournal of Power Sources, 2011
- Ageing mechanisms in lithium-ion batteriesJournal of Power Sources, 2005