Reliability Improvement with Optimized BEOL Process in Advanced DRAM
Authors:
- 1 March 2023
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-4
Abstract
Advanced DRAM with the reduced dangling bonds defects for the transistors could be manufactured by temperature control of passivation and optimizing BEOL process application. The decrease in passivation temperature increased hydrogen ion diffusion from the passivation layer. Passivation of the dangling bonds resulted in the increase of the retention time. Negative bias temperature instability (NBTI) of periphery device was relatively constant due to the pre-existing Si-H bonds. However, back end of line (BEOL) reliability showed drastic deterioration in time dependent dielectric breakdown (TDDB) and electro-migration (EM). Deterioration of Cu adhesion by water molecules and void formation was the main factor of drastic exacerbation of TDDB and EM lifetime. In order to strengthen the Cu adhesion, the optimized BEOL process was applied and the BEOL reliability was improved. As a result, the DRAM cell characteristic has been improved.Keywords
This publication has 6 references indexed in Scilit:
- Backscattering and common-base current gain of the Graphene Base Transistor (GBT)Microelectronic Engineering, 2015
- Effect of annealing on the surface microstructural evolution and the electromigration reliability of electroplated Cu filmsJournal of Electronic Materials, 2001
- Passivation and depassivation of silicon dangling bonds at the Si/SiO2 interface by atomic hydrogenApplied Physics Letters, 1993
- Studies of the hydrogen passivation of silicon grain boundariesJournal of Applied Physics, 1981
- Enhanced conductivity in plasma-hydrogenated polysilicon filmsApplied Physics Letters, 1980
- Hydrogenation and dehydrogenation of amorphous and crystalline siliconApplied Physics Letters, 1978