Interface microstructure of alumina mechanically metallized with Ti brazed to Fe–Ni–Co using different fillers
Authors:
- R.M. NascimentoRNR.M. Nascimento
- A.E. MartinelliAMA.E. Martinelli
- A.J.A. BuschinelliABA.J.A. Buschinelli
- E. SigismundESE. Sigismund
Open Access
- 1 September 2007
- journal article
- Published by Elsevier in Materials Science and Engineering: A
- Vol. 466 (1-2) , 195-200
Abstract
No abstract availableKeywords
This publication has 20 references indexed in Scilit:
- Brazing temperature and time effects on the mechanical properties of TiC cermet/Ag–Cu–Zn/steel jointsMaterials Science and Engineering: A, 2006
- Interfacial microstructure of the Si3N4/Si3N4 joint brazed with Cu–Pd–Ti filler alloyJournal of the European Ceramic Society, 2006
- Joining mechanism in Si3N4 bonded with a Ni–Cr–B interlayerJournal of the European Ceramic Society, 2003
- Active brazing of pure alumina to Kovar alloy based on the partial transient liquid phase (PTLP) technique with Ni–Ti interlayerJournal of the European Ceramic Society, 2002
- Brazing of zirconia with AgCuTi and SnAgTi active filler metalsMetallurgical and Materials Transactions A, 2000
- Furnace and laser methods of bonding metals to ceramics: phenomenological investigationMaterials Science and Engineering: B, 2000
- Joining of alumina using a V-Active filler metalScripta Materialia, 1999
- Metallurgical reactions controlling the brazing of Al2O3 with Ag–Cu–Ti filler alloysJournal of Materials Research, 1998
- Kinetic and microstructural aspects of the reaction layer at ceramic/metal braze jointsJournal of Materials Science, 1996
- Status of the Automotive Ceramic Gas Turbine Development ProgramJournal of Engineering for Gas Turbines and Power, 1993