Design Considerations for Frequency Shifts in a Laterally Finite FBAR Sensor in Contact With the Newtonian Liquid
- 1 July 2020
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control
- Vol. 67 (11) , 2402-2412
Abstract
Mode coupled vibrations in a thickness-shear (TSh) mode and laterally finite FBAR sensor with one face in contact with Newtonian (linearly viscous and compressional) liquid are investigated. With boundary conditions and interface continuity conditions, exact dispersion curves in FBAR sensor contacting with two kinds of liquids are obtained, and they are compared with the dispersion curves in a bare sensor without liquid contact. Frequency spectra, describing mode couplings between the main TSh modal branch and undesirable modal branches, are calculated by employing weak boundary conditions at lateral free edges constructed based on the variational principle. Mode shapes of mechanical displacements in both the sensor and liquid layer are presented, and mode transformations are observed due to the liquid contact and lateral edge effect. The effect of liquid thickness on frequency spectra is also studied. Numerical results reveal that the generation of shear wave in the liquid layer results in the shifts of spectrum curves along the frequency axis and hence it is the main factor of frequency shifts of FBAR sensors. The compressional wave causes the shifts of spectrum curves along the lateral aspect ratio axis. Then for a given FBAR sensor, the liquid thickness changes could also cause frequency shifts. Therefore, desirable vibration modes should be chosen based on the frequency spectra to avoid strong mode couplings and to eliminate frequency shifts induced by the liquid thickness changes in real applications.Keywords
Funding Information
- National Natural Science Foundation of China (11502108, 1611530686, 11772163)
- State Key Laboratory of Mechanics and Control of Mechanical Structures at NUAA (MCMS-E-0520K02)
- Key Laboratory of Impact and Safety Engineering, Ministry of Education at Ningbo University (CJ201904)
- Russian Foundation of Basic Research (20-07-00139)
- Funding for Outstanding Doctoral Dissertation in NUAA (BCXJ18-01)
- Russian Ministry of Science and Education
This publication has 24 references indexed in Scilit:
- Wave propagation in piezoelectric layered structures of film bulk acoustic resonatorsUltrasonics, 2016
- Sensitivity analysis of multi-layered C-axis inclined zigzag zinc oxide thin-film resonators as viscosity sensorsIEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control, 2014
- Viscosity sensor using ZnO and AlN thin film bulk acoustic resonators with tilted polar c-axis orientationsJournal of Applied Physics, 2011
- Shear Mode ZnO Thin Film Applied in FBAR SensorAdvanced Materials Research, 2011
- Thickness vibration of piezoelectric plates of 6mm crystals with tilted six-fold axis and two-layered thick electrodesUltrasonics, 2009
- Shear mode AlN thin film electro-acoustic resonant sensor operation in viscous mediaSensors and Actuators B: Chemical, 2007
- Development of Piezoelectric Thin Film Resonator and Its Impact on Future Wireless Communication SystemsJapanese Journal of Applied Physics, 2005
- Compressional acoustic wave generation in microdroplets of water in contact with quartz crystal resonatorsJournal of Applied Physics, 2001
- Frequency of a quartz microbalance in contact with liquidAnalytical Chemistry, 1985
- Thickness-Shear and Flexural Vibrations of Contoured Crystal PlatesJournal of Applied Physics, 1954