Thermal Compression Bonding of 30um Pitch Cu Pillar Microbump on Organic Substrate with Bare Cu Bondpad
Authors:
- 18 August 2016
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 936-942
Abstract
This paper reports on the development of packaging technology for the assembly of 30μm pitch micro Cu pillar bump (15μm diameter) on organic FCCSP substrate having bare Cu bondpad without NiAu or OSP surface protection. The assembly was performed by thermal compression bonding (TCB) with non-conductive paste (NCP). Finite element modeling and simulation were carried out to understand the Cu pillar structure impact on the TC reliability. The Cu pillar microbump reliability was assessed by thermal cycling (TC) and electromigration (EM) tests. It was found that by the combination of limiting substrate's thermal exposure, shortening the TCB bonding time, and use snap cure NCP can help minimizing the offset between Cu pillar and substrate bondpad during assembly. The presence of larger solder volume reduces the filler particle entrapment severity, crack initiation and propagation thus prolonging the fatigue life of interconnect joints. Given sufficient solder cap volume (16mm height), the 15μm diameter, 30μm pitch Cu pillar interconnect has passed MSL3+3x260°C reflow, high temperature storage at 150°C for 1000hours and 1,000x thermal cycle test at -55°C/+125°C extreme temperatures.Keywords
This publication has 4 references indexed in Scilit:
- Stress Analysis and Design Optimization for Low- $k$ Chip With Cu Pillar InterconnectionIEEE Transactions on Components, Packaging and Manufacturing Technology, 2015
- Alternative fine pitch solution of low cost and high throughput thermal compression bonding by using capillary underfill2015
- Fatigue Reliability Analysis of Sn–Ag–Cu Solder Joints Subject to Thermal CyclingIEEE Transactions on Device and Materials Reliability, 2012
- Fatigue life models for SnAgCu and SnPb solder joints evaluated by experiments and simulation2003