High‐Temperature Resistant Composites in the AlN–SiC–MoSi 2 System
Authors:
- 1 October 2003
- journal article
- Published by Wiley in Journal of the American Ceramic Society
- Vol. 86 (10) , 1720-1726
Abstract
Two fully dense composites containing AlN, SiC, and MoSi 2 in different amounts were produced by hot pressing. Young modulus, hardness, electrical conductivity, and thermal expansion coefficient were measured at room temperature. Strength and toughness were evaluated up to 1300°C in air. According to statistical analysis, the temperature has little or no effect on high‐temperature fracture behavior of the composites. These electroconductive materials are suitable for thermomechanical applications at high temperature, the strength being about 600 MPa at 1300°C.Keywords
This publication has 27 references indexed in Scilit:
- Relations between microstructure, electrical percolation and corrosion in metal—insulator compositesMaterials Science and Engineering: A, 2002
- On the rule of mixtures for the hardness of particle reinforced compositesMaterials Science and Engineering: A, 2000
- Phase identification in reactively sintered molybdenum disilicide compositesMaterials Science and Engineering: A, 1999
- Key developments in high temperature structural silicidesMaterials Science and Engineering: A, 1999
- Processing and properties of MoSi2–SiC and MoSi2–Al2O3Materials Science and Engineering: A, 1999
- Fabrication and characterization of SiC/MoSi2 compositesMaterials Science and Engineering: A, 1998
- In Situ Processing and Properties of SiC/MoSi2 NanocompositesJournal of the American Ceramic Society, 1998
- Hot‐Pressed MoSi2‐Particulate‐Reinforced α‐SiAlON CompositesJournal of the American Ceramic Society, 1995
- Processing of molybdenum disilicideJournal of Materials Science, 1994
- Phase Relationships in Y-Si-Al-O-N Ceramics1986