The Polymer Film Casting Process – An Overview
Authors:
- 1 July 2021
- journal article
- research article
- Published by Walter de Gruyter GmbH in International Polymer Processing
- Vol. 36 (3) , 264-275
Abstract
Cast film extrusion allows producing technical polymer films for packaging and coating applications. Different kinds of defects may be observed. For packaging applications, the challenge is to obtain very thin films in stable conditions at the highest throughput. For coating applications, the challenge is to master the film width reduction (called neck-in) and the induced non-uniform film thickness (called dog-bone defect). Well instrumented experiments point out the influence of the polymer and of the processing conditions on the occurrence of these defects. Numerical models of increasing complexity allow capturing the main experimental features and this makes possible to propose technological solutions to delay or even to suppress defects occurrence.Keywords
This publication has 28 references indexed in Scilit:
- An Overview of Molten Polymer Drawing InstabilitiesInternational Polymer Processing, 2014
- The draw ratio–Deborah number diagram: A useful tool for coating applicationsPolymer Engineering & Science, 2006
- Numerical Simulation of the Film Casting ProcessInternational Polymer Processing, 1999
- Analysis of Temperature Fields in Film CastingJournal of Polymer Engineering, 1999
- Viscoelastic effects in film casting1995
- Stationary and Dynamic Analysis of Film Casting ProcessInternational Polymer Processing, 1994
- Isothermal and Anisothermal Models for Cast Film ExtrusionInternational Polymer Processing, 1992
- Instability Phenomena in Film Casting ProcessInternational Polymer Processing, 1990
- Draw resonance in film casting of viscoelastic fluids: A linear stability analysisJournal of Non-Newtonian Fluid Mechanics, 1988
- Causes of edge beads in cast filmsPolymer Engineering & Science, 1986