Enhanced Resolution, Throughput, and Stability of Aerosol Jet Printing via In Line Heating
Open Access
- 12 March 2024
- journal article
- research article
- Published by Wiley in Advanced Functional Materials
- Vol. 34 (28)
Abstract
Aerosol jet printing offers high resolution, broad materials compatibility, and digital patterning for flexible, conformal, and hybrid electronics. However, limited throughput, instability, and complex optimization requirements inhibit translation to industrial applications. An in‐line heater integrated on a custom printer is demonstrated to modulate droplet evaporation in the aerosol phase, thereby decoupling the deposition rate of functional solids and liquid ink to enable taller, narrower features with aspect ratios reaching 0.29 for a single line. Heating the printhead from room temperature to 80 °C reduced the sensitivity of resolution to deposition rate by ≈90%, improving reliability. With this strategy, increasing the linear deposition rate by 10x results in a modest increase of 27% in line width, compared to a four‐fold increase without heating, permitting higher throughput without sacrificing print quality. Providing a control for in‐line drying independent of ink formulation enables rapid, straightforward design of new materials and processes. This ability to engineer drying of droplets prior to impingement provides a versatile tool to meet complex fabrication challenges, as demonstrated here for both high aspect ratio printing and conformal patterning on rough and three‐dimensional surfaces.Keywords
Funding Information
- National Science Foundation (NSF CMMI‐2224303)
- Division of Civil, Mechanical and Manufacturing Innovation (2224303)
This publication has 33 references indexed in Scilit:
- All‐Solid‐State Battery Fabricated by 3D Aerosol Jet PrintingAdvanced Engineering Materials, 2023
- Predicting Deposition Rate and Closing the Loop on Aerosol Jet Printing with In‐Line Light Scattering MeasurementsAdvanced Engineering Materials, 2023
- A New Frontier of Printed Electronics: Flexible Hybrid ElectronicsAdvanced Materials, 2019
- 3D Conformal Printing and Photonic Sintering of High‐Performance Flexible Thermoelectric Films Using 2D NanoplatesAdvanced Functional Materials, 2019
- Direct‐Write Printed, Solid‐Core Solenoid Inductors with Commercially Relevant InductancesAdvanced Materials Technologies, 2018
- The Effect of Droplet Sizes on Overspray in Aerosol‐Jet PrintingAdvanced Engineering Materials, 2018
- Aerosol‐Jet Printed Fillets for Well‐Formed Electrical Connections between Different Leveled SurfacesAdvanced Materials Technologies, 2017
- Completely Printed, Flexible, Stable, and Hysteresis‐Free Carbon Nanotube Thin‐Film Transistors via Aerosol Jet PrintingAdvanced Electronic Materials, 2017
- 2D Insulator–Metal Transition in Aerosol‐Jet‐Printed Electrolyte‐Gated Indium Oxide Thin Film TransistorsAdvanced Electronic Materials, 2017
- Morphological influences on the electrical sintering process of Aerosol Jet and Ink Jet printed silver microstructuresJournal of Materials Science: Materials in Electronics, 2013