Experimental Measurements of the Flow and Heat Transfer of a Square Jet Impinging on an Array of Square Pin Fins
- 14 June 2005
- journal article
- Published by ASME International in Journal of Electronic Packaging
- Vol. 128 (1) , 61-70
Abstract
The flow behavior and heat transfer due to free air jet impingement on pin fin heat sinks was experimentally studied. Flow velocities and tip clearance ratios were varied from 2to20m∕s and 0 to 1, respectively. The stagnation pressure recovered at the center of the heat sink was higher for tall pins than for short pins. The pressure loss coefficient showed little dependence on Re, increased with increasing pin density and pin diameter, and decreased with increasing pin height and clearance ratio. The overall base-to-ambient thermal resistance decreased with increasing Re number, pin density, and pin diameter.Keywords
This publication has 5 references indexed in Scilit:
- Experiments and modeling of the hydraulic resistance and heat transfer of in-line square pin fin heat sinks with top by-pass flowInternational Journal of Heat and Mass Transfer, 2005
- Experimental Measurements of the Flow and Heat Transfer of a Square Jet Impinging on an Array of Square Pin Fins2002
- Enhancement of air jet impingement heat transfer using pin-fin heat sinksIEEE Transactions on Components and Packaging Technologies, 2000
- Experimental optimization of confined air jet impingement on a pin fin heat sinkIEEE Transactions on Components and Packaging Technologies, 1999
- Describing the uncertainties in experimental resultsExperimental Thermal and Fluid Science, 1988