Sintering Behaviour and Performance Data of High Speed Steel Components
Authors:
- R. WählingRWR. Wähling
- P. BeissPBP. Beiss
- W. J. HuppmannWHW. J. Huppmann
- 1 January 1986
- journal article
- Published by SAGE Publications in Powder Metallurgy
- Vol. 29 (1) , 53-56
Abstract
To obtain effective sintering of high speed steel powder compacts to full density it is essential to balance the oxides present on the powder particle surface with the correct amount of added carbon, since the sintering temperature depends critically on the residual carbon content after the oxides have been reduced. In this paper the underlying relation-ships, derived from experimental sintering runs, are presented. Conclusions for the sintering of actual components are derived and compared with practical production experience. It is shown that inadequate carbon control leads to incomplete densification and to component distortion. Performance data for sintered products such as cutting inserts are presented. PM/0342Keywords
This publication has 6 references indexed in Scilit:
- Mechanical Properties and Cutting Performance of Sintered M2 High Speed SteelPowder Metallurgy, 1983
- Thelot Claude — Tel père, tel fils ? Position sociale et origine familialePopulation, 1983
- Comparison of Strength and Toughness of Wrought and Directly Sintered T6 High-Speed SteelPowder Metallurgy, 1979
- THE PREPARATION OF CARBIDE-ENRICHED TOOL STEELS BY POWDER METALLURGYPowder Metallurgy, 1973
- THE FABRICATION OF HIGH-SPEED TOOL STEEL BY ULTRAFINE POWDER METALLURGYPowder Metallurgy, 1973
- Solidification of M2 high speed steelMetallurgical Transactions, 1972