A Modal Conditional Mean Spectrum for Nonlinear Structural Response Time-History Analysis of Tall Buildings to Consider Higher Mode Effects
Preprint
- 8 June 2023
- preprint
- Published by Springer Nature in Research Square
Abstract
Selection and scaling of an appropriate suite of earthquake ground motion records for consistency with a target spectrum are associated with nonlinear structural response time-history analysis. The commonly used target spectrum could be a uniform hazard spectrum (UHS), conditional (mean) spectrum (CMS or CS). The CMS (CS) overcomes the limitations of the “overly conservative” and “unrealistic spectral shape” of UHS and has been accepted as a more reasonable target spectrum recently. However, the CMS only selects a single conditional period (usually the first period T1 of the structure) ignoring the influence of the high-order vibration mode (other periods) on the structure. To address this, this paper proposes a modal conditional mean spectrum (MCMS) considering the influence of higher-order modes by weighted (measured using the modal participation mass ratio) averaging the CMS under each period of the structure. The MCMS matches CMS(T1) at a period T" (T"< T1). The spectrum values of MCMS are significantly higher than those of CMS(T1) for periods shorter than T" and slightly lower than those of CMS(T1) for periods longer than T". Then, two typical high-rise case structures (symmetric and asymmetric structures) with different elevations are designed, and the MCMS, CMS(T1) and UHS are used as target spectra for nonlinear structural response time-history analysis for comparison. Based on the analysis of four engineering demand parameters, namely peak floor acceleration (PFA), peak floor velocity (PFV), peak floor displacement (PFD), and maximum interstory drift ratio (IDR), it was found that the results of the UHS were consistently higher than those of the CMS(T1) and the MCMS. However, it was also observed that the PFA results of MCMS were higher than those of CMS(T1), whereas the PFD, PFV, and IDR results of MCMS were lower than those of CMS(T1). It should be noted that MCMS is a target spectrum that takes into account the influence of higher-order mode effects in CMS.Keywords
All Related Versions
This publication has 29 references indexed in Scilit:
- Conditional spectrum‐based ground motion selection. Part I: Hazard consistency for risk‐based assessmentsEarthquake Engineering & Structural Dynamics, 2013
- Conditional spectrum‐based ground motion selection. Part II: Intensity‐based assessments and evaluation of alternative target spectraEarthquake Engineering & Structural Dynamics, 2013
- A ground motion selection algorithm based on the generalized conditional intensity measure approachSoil Dynamics and Earthquake Engineering, 2012
- A new indicator of elastic spectral shape for the reliable selection of ground motion recordsEarthquake Engineering & Structural Dynamics, 2011
- A generalized conditional intensity measure approach and holistic ground‐motion selectionEarthquake Engineering & Structural Dynamics, 2010
- Vector-valued Intensity Measures Incorporating Spectral Shape For Prediction of Structural ResponseJournal of Earthquake Engineering, 2008
- Evaluation of the seismic performance of a code‐conforming reinforced‐concrete frame building—from seismic hazard to collapse safety and economic lossesEarthquake Engineering & Structural Dynamics, 2007
- Spectral shape, epsilon and record selectionEarthquake Engineering & Structural Dynamics, 2006
- A vector-valued ground motion intensity measure consisting of spectral acceleration and epsilonEarthquake Engineering & Structural Dynamics, 2005
- Hazard-consistent earthquake scenariosSoil Dynamics and Earthquake Engineering, 2000