Experimental Study of the Microstructure and Stress of Electroplated Gold for Microsystem Applications
Authors:
- 1 January 2003
- journal article
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 150 (6) , C445-C450
Abstract
Gold, used as an X-ray absorber for lithography and as a structural or conducting material in microsystems, was deposited from a commercially available sulfite electrolyte. The effects of current type and an arsenic additive on the gold microstructure and residual stress were studied. Using a simple bent strip method, good agreement with literature stress values determined via other methods was obtained. Without arsenic, residual stresses are tensile (∼50 MPa)(∼50 MPa) regardless of current type. With 25 ppm arsenic, the stress is compressive for direct current (ca. −30 MPa),−30 MPa), with pulsed current reducing the stress to <−5 MPa<−5 MPa compressive; this has been noted previously with thallium as an additive. The addition of arsenic does not appreciably change the film grain size but does lower the twin density and modify texture. Pores were observed in all the gold films, but were larger and less concentrated for films produced with arsenic; for the case of direct current with arsenic, the pores were concentrated at the grain boundaries. Consistencies in the microstructural observations and thin film stress theories are discussed. © 2003 The Electrochemical Society. All rights reserved.Keywords
This publication has 13 references indexed in Scilit:
- Physical Origins of Intrinsic Stresses in Volmer–Weber Thin FilmsMRS Bulletin, 2002
- Electrostatic Actuators with Intrinsic Stress GradientJournal of the Electrochemical Society, 2002
- LIGA Technologies and ApplicationsMRS Bulletin, 2001
- Additive Effects during Pulsed Deposition of Cu-Co NanostructuresJournal of the Electrochemical Society, 2000
- Some recent topics in gold plating for electronics applicationsGold Bulletin, 1998
- Evaluation of a non-cyanide gold plating process for switch tubes1996
- Effect of the Cl− and SO42− ions on the selective orientation and structure of Ni electrodepositsElectrochimica Acta, 1995
- Electrodeposition of low stress gold for x-ray maskJournal of Vacuum Science & Technology B, 1990
- Production of separation-nozzle systems for uranium enrichment by a combination of X-ray lithography and galvanoplasticsThe Science of Nature, 1982
- The characteristics of small gas-filled voids in electrodeposited goldMetallography, 1971