Corrective finishing of extreme ultraviolet photomask blanks by precessed bonnet polisher
- 8 May 2014
- journal article
- research article
- Published by Optica Publishing Group in Applied Optics
- Vol. 53 (14) , 3075-3080
Abstract
The progressive transition from Excimer to extreme ultraviolet (EUV) lithography is driving a need for flatter and smoother photomask blanks. It is, however, proving difficult to meet the next-generation specification with the conventional chemical mechanical polishing technology commonly used for finishing photomask blanks. This paper reports on the application of subaperture computer numerical control precessed bonnet polishing technology to the corrective finishing of photomask substrates for EUV lithography. Full-factorial analysis was used to identify process parameters capable of delivering microroughness below 0.5 nm rms while retaining relatively high removal rates. Experimental results show that masks prepolished to 300–600 nm peak-to-valley (P-V) flatness by chemical/mechanical polishing can then be improved down to 50–100 nm P-V flatness using the automated technology described in this paper. A series of edge polishing experiments also hints at the possibility of increasing the quality area beyond the 142 mm square defined in the official EUV photomask specification.Keywords
Funding Information
- Japan Society for the Promotion of Science (JSPS) (22360063)
This publication has 9 references indexed in Scilit:
- Edge control in CNC polishing, paper 2: simulation and validation of tool influence functions on edgesOptics Express, 2013
- Super-smooth finishing of diamond turned hard X-ray molding dies by combined fluid jet and bonnet polishingCIRP Annals, 2013
- Edges in CNC polishing: from mirror-segments towards semiconductors, paper 1: edges on processing the global surfaceOptics Express, 2012
- Development status of EUVL mask blank and substrate2011
- Finishing of optical moulds to λ /20 by automated corrective polishingCIRP Annals, 2011
- Research on edge control in the process of polishing using ultra precise bonnet on optical elements2010
- Improvement of total quality on EUV mask blanks toward volume production2010
- Use of the ‘Precessions’™ process for prepolishing and correcting 2D & 2½D formOptics Express, 2006
- Chemical processes in glass polishingJournal of Non-Crystalline Solids, 1990