Macromodel of Spatial Smoothing in Wind Farms
Authors:
- 20 February 2007
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Energy Conversion
- Vol. 22 (1) , 119-128
Abstract
Departing from aerodynamics (micromodel), the macromodel begins with the power output of a single wind turbine generator (WTG). The N units of WTGs in a wind farm are characterized by the time delays it takes wind, at average velocity, to traverse the distances separating them. Predictions from simulations are in agreement with recorded wind farm data. Smoothing of high-frequency power components is by a factor close to N-1/2. Smoothing of low-frequency harmonic power components is small because the wind farm is limited in size. A theory, based on Fourier analysis, is presented to explain how the macromodel simultaneously copes with: 1) the high-frequency components of wind velocity (which have poor correlation) even for short distances and 2) the low-frequency components (which have some correlation)Keywords
This publication has 6 references indexed in Scilit:
- Estimation of Wind Penetration as Limited by Frequency DeviationIEEE Transactions on Energy Conversion, 2007
- Strategies to Smooth Wind Power Fluctuations of Wind Turbine GeneratorIEEE Transactions on Energy Conversion, 2007
- Frequency Deviation of Thermal Power Plants Due to Wind FarmsIEEE Transactions on Energy Conversion, 2006
- Wind Power in Power Systems: An Introduction2005
- Spectral characteristics of surface‐layer turbulenceQuarterly Journal of the Royal Meteorological Society, 1972
- The spectrum of horizontal gustiness near the ground in high windsQuarterly Journal of the Royal Meteorological Society, 1961