Optimal curing for thermoset matrix composites: Thermochemical and consolidation considerations
- 1 October 2002
- journal article
- research article
- Published by Wiley in Polymer Composites
- Vol. 23 (5) , 739-757
Abstract
A design sensitivity method is used to find optimal autoclave temperature and pressure histories for curing of thermoset‐matrix composite laminates. The method uses a finite element simulation of the heat transfer, curing reaction, and consolidation in the laminate. Analytical sensitivities, based on the direct differentiation method, are used within the finite element simulation to find the design sensitivities, i.e., the derivatives of the objectives function and the constraints with respect to the design variables. Standard gradient‐based optimization techniques are then used to systematically improve the design, until an optimal process design is reached. In this study the objective is to minimize the total time of the cure cycle, while the constraints include a maximum temperature in the laminate (to avoid thermal degradation) and a maximum deviation of the final fiber volume fraction from its target value (to achieve proper consolidation). The simulations of curing process are performed for EPON 862/W epoxy under a conventional cure cycle, for both thin and thick parts. Time‐optimal cure cycles are found using the optimization program. Simulations of fast‐curing cycles are also examined. The optimal cycles are similar in form to conventional cure cycles, but give substantially shorter cure times. The entire scheme works automatically and efficiently, simultaneously adjusting multiple design variables at each iteration.Keywords
This publication has 20 references indexed in Scilit:
- Application of genetic algorithms to optimal tailoring of composite materialsComposites Science and Technology, 1998
- Optimisation of the co-curing of two different composites with the aim of minimising residual curing stress levelsComposites Science and Technology, 1998
- Rapid cure simulation using artificial neural networksComposites Part A: Applied Science and Manufacturing, 1997
- Intelligent Curing of Thick Composites Using a Knowledge-Based SystemJournal of Composite Materials, 1997
- Optimal design of the cure cycle for consolidation of thick composite laminatesPolymer Composites, 1996
- Expert Cure System for the Carbon Fiber Epoxy Composite MaterialsJournal of Composite Materials, 1995
- The Consolidation of Laminate CompositesJournal of Composite Materials, 1987
- Curing of Epoxy Matrix CompositesJournal of Composite Materials, 1983
- Resin Flow During the Cure of Fiber Reinforced CompositesJournal of Composite Materials, 1982
- The effect of deformation and thermoset cure on heat conduction in a chopped-fiber reinforced polyester during compression moldingInternational Journal of Heat and Mass Transfer, 1979