Investigation of the Scanning Microarc Oxidation Process
Open Access
- 1 January 2017
- journal article
- research article
- Published by Wiley in Advances in Materials Science and Engineering
- Vol. 2017, 1-12
Abstract
Scanning microarc oxidation (SMAO) is a coating process which is based on conventional microarc oxidation (MAO). The key difference is that deposition in SMAO is achieved by using a stainless steel nozzle to spray an electrolyte stream on the substrate surface as opposed to immersing the workpiece in an electrolyzer. In the present study, SMAO discharge characteristics, coating morphology, and properties are analyzed and compared to results obtained from MAO under similar conditions. Results show that MAO and SMAO have comparable spark and microarc lifetimes and sizes, though significant differences in incubation time and discharge distribution were evident. Results also showed that the voltage and current density for MAO and SMAO demonstrate similar behavior but have markedly different transient and steady-state values. Results obtained from coating A356 aluminum sheet show that oxide thickness and growth rate in SMAO are strongly dependent on interelectrode spacing and travel speed. Analysis of the SMAO coating morphology and structure showed that a denser and slightly harder layer was deposited in comparison to MAO and is attributed to reduced porosity and increased formation of α-Al2O3. Preliminary results indicate that SMAO represents a viable process for coating of aluminum surfaces.Keywords
Funding Information
- National Natural Science Foundation of China (51371022, 2015JBM076)
- Central College Basic Scientific Research Business Expenses Special Funds (51371022, 2015JBM076)
This publication has 28 references indexed in Scilit:
- Coloration of the aluminum alloy surface with dye emulsions while growing a plasma electrolytic oxide layerSurface and Coatings Technology, 2016
- Effect of Na 2 SiO 3 ·5H 2 O concentration on microstructure and mechanical properties of plasma electrolytic oxide coatings on AZ31 Mg alloy produced by twin roll castingCeramics International, 2016
- A comparison of corrosion, tribocorrosion and electrochemical impedance properties of pure Ti and Ti6Al4V alloy treated by micro-arc oxidation processApplied Surface Science, 2015
- Characterization and thermal shock behavior of composite ceramic coating doped with ZrO2 particles on TC4 by micro-arc oxidationApplied Surface Science, 2014
- Preparation, antibacterial effects and corrosion resistant of porous Cu–TiO2 coatingsApplied Surface Science, 2014
- Wear-resistant coatings formed on Zircaloy-2 by plasma electrolytic oxidation in sodium aluminate electrolytesElectrochimica Acta, 2014
- Preparation of PEO ceramic coating on Ti alloy and its high temperature oxidation resistanceCurrent Applied Physics, 2010
- Investigation of the mechanism of plasma electrolytic oxidation of aluminium using 18O tracerCorrosion Science, 2010
- Thermo-physical properties of plasma electrolytic oxide coatings on aluminiumSurface and Coatings Technology, 2005
- Anodic processes in plasma electrolytic oxidation of aluminium in alkaline solutionsElectrochimica Acta, 2004